Exactly, Dan! :thumbsup:
That's the video where about 2 minutes into it, Jody just sets up the stinger with a 7014 rod and lets it lay down a nice looking bead by itself.
Can't get no easier than that. :cool2:
How do I know what kind of welding rods to buy??
- Thread starter spencerfarmsparmaidaho
- Start date
- Views: 3446
Exactly, Dan! :thumbsup:
That's the video where about 2 minutes into it, Jody just sets up the stinger with a 7014 rod and lets it lay down a nice looking bead by itself.
Can't get no easier than that. :cool2:
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 7,047
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Like mentioned, 7014 is a good rod for general use - it also re-strikes very easy and runs well on AC as well. Run it hot, drag the flux on the plate, and take a nap - yeah, it's that easy sometimes
I stopped using 7014 for this very reason. Figured naps while welding wasn't a very good mix......
Terry
:laughing: Yeah, what's the incentive in enjoying welding, if it's just going to weld itself?
MinnesotaDaveChalmers
Platinum Member
Heck, the older I get, the more a good nap now-and-then is a very nice thing
:laughing: Yeah, what's the incentive in enjoying welding, if it's just going to weld itself?
That's why I buy really old welders, they already know where to put the weld...
...then I chuck up a 7014, which already know how to weld itself...
...then I take a little cat-nap :laughing:
Loghomeguy
New member
I use 1/8 inch 6011 for the dirty work, and 3/32 and 1/8 7018 for verts and overhead. Also like 1/8 7024 for pretty flat welds.
