How to convert cat 0 to cat I

[JeffinNE]

Found a nice, newer JD cat 0 single bottom plow on craigslist. How hard (and expensive) to convert to cat I to pull behind a JD 2320?
I have no welding equipment nor welding skills!

 

[greg_g]

I hope you didn't buy it. Cat 1 tractors usually do a pretty good job of destroying Cat 0 implements

//greg//

 

[bigtiller]

I tried to do that with my 2305 and it didn't work. The lift arms would not move in close enough to connect to the plow. I believe the adjustment for the lift arms is the same as on your 2320. And even if I could have "made" it fit, the top link was to wide to fit onto the plow. I ended up making my own mast for the plow.

 

[tw30]

i dont know about cat 0. but cat 1 and cat 2 3 point attachments well cat 2 tractor doesnt have problems using cat 1 pins.someone i know all of their implements are cat 1 while their tractor is cat 2 and they never had any difficulty using them . and you can just buy big pins if need be . but again for the cat 0 the probably to small for the arms to reach