I cry Uncle. I need help.

   / I cry Uncle. I need help. #11  
Once you get that snap ring out, the bearing will probably need to be pressed out and the new one pressed back in.
 
   / I cry Uncle. I need help. #12  
I just rebuilt the mower for my dad's 314. It uses the same hubs in the mower. Remove the snap ring with a screwdriver(s). Press or drive out the shaft with hammer and drift. Drive out the old bearings there's a spacer between the bearings. Clean up the hub, reinstall the new bottom bearing and snap ring. Install the shaft and the spacer. Fill the hup 75% full of grease then install the top bearing and pulley....voila.
 
   / I cry Uncle. I need help.
  • Thread Starter
#13  
I did get the ring out. I started making progress when a friend showed up for the town Easter egg hunt. That third hand really makes a difference.

Mighty Dodge said:
I just rebuilt the mower for my dad's 314...

You forgot to mention the second snap ring inside the hub. I beat on that poor bearing with everything I had before I figured out that second snap ring.
 
   / I cry Uncle. I need help. #14  
Sandlot has the ticket!

Soundguy
 

Tractor & Equipment Auctions

2014 MACK GRANITE GU713 TRI AXLE DUMP TRUCK (A45678)
2014 MACK GRANITE...
2004 GMC W4500 (A47307)
2004 GMC W4500...
2015 Ford F-150 XLT (A47307)
2015 Ford F-150...
Polaris Lock & Ride Tool Box (A49339)
Polaris Lock &...
2016 Big Tex 14LX 14ft 7 Ton T/A Dump Trailer (A46683)
2016 Big Tex 14LX...
2016 Chevrolet Caprice Sedan (A46684)
2016 Chevrolet...
 
Top