FYI: my splitter is home built, dual way splitter which currently runs of the hydraulics of my John Deere 4100. i'm guessing near
18 tons. I use a standard 20"inch throw cylinder with a 3" shaft. It does good. But would much rather run it off the PTO so I can leave the FEL mounted. I know I can add Power Beyond to the rear. But the small hoses that uses. I feel will slow it down to much
18 tons. I use a standard 20"inch throw cylinder with a 3" shaft. It does good. But would much rather run it off the PTO so I can leave the FEL mounted. I know I can add Power Beyond to the rear. But the small hoses that uses. I feel will slow it down to much
