JD 1050 w/ 75 loader

[cormac_bailey]

Hi, I have a jd 1050 4wd and a jd 75 loader I took off an old 850. Can anyone tell me what parts I need from the selective control valve to the levers and if there are any aftermarket parts that are compatible?

 

[medic0648]

Your tractor may already be setup for a power beyond. I'll have to pull out my service manual if I get a chance and see where it is supposed to be and how to set it up.

 

[cormac_bailey]

Thanks. I contacted my local JD dealer and they were of little help. Basically told me the part was obsolete and I was out of luck.

 

[medic0648]

According to my service manual a lot of the 850-1050 were setup with the divider block at the factory.

 

[medic0648]

The divider block should be directly behind the 3pt sector control if installed. It will be a little block with hydraulic lines and a small pressed metal lever on top if you have it. If you have power steering it is most likely plumbed from the diverter.

 

[Barry 1]

You need to buy a two spool loader valve like The one at Portable Generators, Pressure Washers, Power Tools, Welders | Northern Tool + Equipment # 34A126420 (item #2015) and you need the Power Beyond adapter (PM 660 280 001) and mount it on the loader. There are lots of others that will work,but this was what I used on my 1050. I have power steering-do you? I will have to go look,to see how I plumbed it,but I went by the service manual,and you should buy one too. Any valve you get should have pressure relief and power beyond.
If you want to go factory setup,there is a valve on Ebay (AM107083) and you can look up jdparts.deere.com and see how it all goes together,and they might still have the levers and rest of it.

 

[cormac_bailey]

Thanks for the advise... Just ordered shop manual! Mine does not have power steering however the jd 850 I took the loader off didn't either. As far as the power beyond adapter, what company did that part number come from? I didn't see it at John Deere or northern tool. Again thanks for the help!

 

[cormac_bailey]

I just checked and it does have the divider block...

 

[medic0648]

When you get your service manual it will show you how to plumb it. There should be 2 plugs on the broad side of the divider that you would attach to. This would be a good time to setup some scv and/or power beyond on the rear of the tractor. Also if you ever think you may want a grapple or other hydraulic accessory on the leader a 3rd function would be cheaper to add now with a 3 spool valve.

 

[Barry 1]

For the PB adapter,for item #2015-look in the accessorys list,or the questions and answers below the valve picture-it's there somewhere.You have to get the right one for the valve. Whatever you get,be sure it has PB option,some do,some don't.They also have a cheaper, cross monoblock loader valve w/PB

 

[cormac_bailey]

is there a kit to mount this to the tractor? if you have any pics of your setup I would really appreciate seeing them! Thanks for all the help!!