buickanddeere
Super Member
Any power when in gear driving around? Is the hydraulics the only function that Boggs the engine ?
JD 401 hydraulic problem
- Thread starter southwind26
- Start date
- Views: 11973
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,589
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
southwind
Someone recently pointed out a place that makes up a hose and gauge, and looked like a good setup ready to go.
Ken's Bolt on Grab Hooks <<Hydraulics>>
Someone recently pointed out a place that makes up a hose and gauge, and looked like a good setup ready to go.
Ken's Bolt on Grab Hooks <<Hydraulics>>
OP
southwind26
New member
- Joined
- Mar 1, 2014
- Messages
- 21
- Location
- ash fork, az
- Tractor
- 1971 John Deere 60hp model #401AJ, serial # 190601T with a #7310 loader with 1 yard bucket. Engine type 4202DT 4 cylinder diesel, serial #279020T with detachable backhoe model # 9250 has a 24 bucket with good teeth. John Deere considered this mode
Yes there is, I was driving in first gear / 4th and I could feel the tractor slowing down going over a bump in the dirt.
OP
southwind26
New member
- Joined
- Mar 1, 2014
- Messages
- 21
- Location
- ash fork, az
- Tractor
- 1971 John Deere 60hp model #401AJ, serial # 190601T with a #7310 loader with 1 yard bucket. Engine type 4202DT 4 cylinder diesel, serial #279020T with detachable backhoe model # 9250 has a 24 bucket with good teeth. John Deere considered this mode
Wow, that set up looks great. Thanks for the web site beenthere
OP
southwind26
New member
- Joined
- Mar 1, 2014
- Messages
- 21
- Location
- ash fork, az
- Tractor
- 1971 John Deere 60hp model #401AJ, serial # 190601T with a #7310 loader with 1 yard bucket. Engine type 4202DT 4 cylinder diesel, serial #279020T with detachable backhoe model # 9250 has a 24 bucket with good teeth. John Deere considered this mode
Guys we got it. It turned out the be the check ball in the return line fitting that goes into the inj pump. The ball was stuck with some debris, cleaned it and BAM !!! she came alive like her old self. That check ball looked a little odd almost like it was a clear plastic ball in the fitting. I just want to thank all of you for your input and patience, what I learned here I will keep for ever......
Tx Jim
New Member
I'm glad you determined your problem. Normally plugging of check ball in return line indicates drive coupler in inj pump is deteriorating and pump will require repair. Engine may run fine for a while BUT be aware that it's possible for engine to over speed IE run away sometime in the future.
