JD2520 - MMM lift

[kennyd]

That said, it is easy to take off the MMM, only problem is that the linkage to support the mower still hangs down and will drag on the ground if you use the TPH in the down position with some attachment like a trailer or boxblade. You can disconnect all the linkage that supports the mower deck, but the lockup kit will prevent the linkage from dragging and allow you full range use of the TPH.

I use cable ties (zip ties) to hold the brackets up to the frame when I remove the deck.

 

[VABlue]

"Is there a height adjustment knob on the 2520? I know there is one on the 2320, but didn't think there was on the 2520."

No knob, huh? Now you know why I didn't buy a 2520 - don't know anything about them.

I was testing you're knowledge of it...

 

[sldva00]

That said, it is easy to take off the MMM, only problem is that the linkage to support the mower still hangs down and will drag on the ground if you use the TPH in the down position with some attachment like a trailer or boxblade. You can disconnect all the linkage that supports the mower deck, but the lockup kit will prevent the linkage from dragging and allow you full range use of the TPH.

I remove the MMM including the linkage that connects to it. It does not take long at all to remove mower and linkage, about 5 minutes the first time I tried. Just don't lose those pins. It is just as easy to put everything back on.