Jimna electrical wire

[Jimmy254]

Can someone please tell me where the black loose wire with the round connector which is hanging over the engine label is supposed to go.

 

[Bob Rooks]

I can better tell you where it goes if you tell me where it's coming from. I see another short black wire on the end of the glow plug bus bar.

 

[piper184]

what is the number on the little yellow plastic tag? There may be another tag on the wire, one for each digit.
It is most likely a ground wire but without more info it is impossible to tell for sure.

 

[Jimmy254]

I didn't think to look closely at the tag. It didn't even think that it was a tag. I'll have another look next opportunity I get.

 

[Jimmy254]

The number on the tag is 44. I cant tell where the other end goes. It comes out of the loom.

 

[piper184]

On the schematics I have seen #44 is always the ground.
Do you have a schematic? If not you can download a copy here:

Harnerfarm Jinma 284

Help yourself to any of the other stuff as well. I didn't create it, just passing it on for others

 

[Bob Rooks]

And black is usually used for ground wires.

 

[Jimmy254]

The schematic indicates ground but i was hoping someone could show me where it is ground. The wire is only about 6 inches long so it has to be around the area shown on my photo right above the engine label on the rocker cover. Is it the rocker cover nut maybe?

 

[piper184]

This is a better one. I need to get it uploaded to my site

 

[piper184]

I think it goes under the top fuse block screw and grounds against the metal bar that holds the block.
Zoom in on this picture and I think you can just barely see it under the block and the tag is next to the horn