JX80

wadem

New member
Joined
May 11, 2015
Messages
3
Location
Mesick, MI
Tractor
IH966,Farmall F12, Case 430, CasiIH jx80
Where is the adjustment for how fast the 3 point goes down on 2008 CaseIH JX80?
I have moved draft control all over the place and still very very very slow to lower 3 point. Trying to use backblade on it.
 
There should be a valve on the floor or in the panel behind your feet that controls the drop rate of the 3 point.
 
I'm pretty sure there is a cable for the lift-o-matic switch on the hitch valve. Hitch valve is under remote valve on top pto. Can adjust the cable to speed drop rate.
 
/ JX80
  • Thread Starter
#4  
Thanks boudreaux81. I found that and adjusted it and you were spot on. Finally someone who actually knows.
 
/ JX80
  • Thread Starter
#6  
now for another problem. It seems to be in 4 wheel drive all the time. Lever moves but obviously won't disengage front drive
 
Yes as previous comment check see if shaft on side transmission is moving along with handle and not just the linkage. Could very well be broken roll pin. Sometimes you have to be slowly moving to disengage also.
 
Then also pinbolt Partno 5129031 that anchor the returnspring partno 5129033..........pinbolt broken off ? spring still there ?
 
Last edited:

Marketplace Items

1200 GALLON FLAT BOTTOM POLY TANK (A64278)
1200 GALLON FLAT...
2017 CATERPILLAR 289D SKID STEER (A65053)
2017 CATERPILLAR...
2011 International 4300 Versalift VST60001 65ft. Insulated Bucket Truck (A64194)
2011 International...
2024 BOBCAT S76 R-SERIES SKID STEER (A65053)
2024 BOBCAT S76...
2017 TROXELL 150 BBL ALUMINUM VACUUM TRAILER (A63569)
2017 TROXELL 150...
2018 Toyota Camry Sedan (A64557)
2018 Toyota Camry...
 
Top