Kioti has officially discontinued the NX Line - still worth buying?

[MinnesotaEric]

Personally I would go with an NS.
The NX line had to many issues IMO.

Are the "issues" in the room with us now?

The NX series suffered from too cold of thermostats when first sold but so did all Teir IV machines which often clogged up the DPF and put them into a limp-home mode. The field solution was to put in warmer t-stat. I run a 180°F T-stat in my NX and the stock was a 160°F which in spring, fall and definitely winter is way, way, way too cold. Keep in mind that as a auto tech I replace standard car t-stats with warmer t-stats as well for our local climate.

The NX HST issue is a solenoid in the transmission. The later machines have a different design. My tractor being a very early model "jerks" as the solenoid goes batty until the trans-hydro fluid warms up and then works fine.

Other than that I've had one alternator go bad, but luckily, a larger alternator from a Mazda 1987 B2000 for $65 pops right in and works with the existing wiring harness.

I did shell the front axle center housing on my NX series, and the equivalent Bobcat to the NX interestingly uses a different front axle housing than Kioti's NX series. Personally, I think the front axle housing is too weak for the loader's rated breakout force. I have not looked at the difference between the NX and NS tractors, but the OP may want to chase on over to his/her Bobcat dealer and make comparisons, take photos, and circle back here with any questions.

 

[Fetchtx1]

I have a 2019 6010 and love it

 

[Fetchtx1]

I have a 2019 NX6010 cab with Armstrong ag grapple and ironcraft
Flail mower- very seldom use bucket with it.

 

[5030]

Yes, we do. There is a "5 paw" Kioti dealer within 30 minutes - they say they are the biggest Kioti seller in the US. We also have Kubota, JD, Mahindra etc. close by.

I wish Kioti had made a 50hp gear-driven NS. They only make an NS5310 HST, no shuttle shift.

The dealer is pricing the NX5010 to move. Should I be worried if I get an NX in shuttle shift instead of HST?

All depends on your intended use. I prefer the hydraulic shuttle on my Kubota's as it totally eliminates the dry chutch and the HST still has a dry clutch. Got well over 6000 hours on both my Kubota's (each) and I've never had to adjust the wet packs ever. I use them hard all the time.

 

[5030]

Gee, I love my wife and my dog but one thing I would never love is my tractors as they are machines as in not able to love me back...
They are for work and to make my life easier and that is it.

They get well fed (diesel fuel) and reqular maintenance and greasing and once in a while, a bath but thats it.

Don't love my pickup truck or my car either. Just machines to make my life easier.

I am fond of my wife's Suburban LTZ 4x4 because she drives and I can ride.....

 

[Torvy]

Yes, we do. There is a "5 paw" Kioti dealer within 30 minutes - they say they are the biggest Kioti seller in the US. We also have Kubota, JD, Mahindra etc. close by.

I wish Kioti had made a 50hp gear-driven NS. They only make an NS5310 HST, no shuttle shift.

The dealer is pricing the NX5010 to move. Should I be worried if I get an NX in shuttle shift instead of HST?

They are the biggest Kioti dealer. Kioti even begged them to drop TYM because they compete so closely. During the troubles, Kioti couldn't keep up with demand, so they added TYM. It cut into Kioti sales once production picked back up.

The good news is they are unlikely to ever drop Kioti and Kioti owes them, so they likely have good luck with parts and inventory.