Kubota 7040 with Landmark 15 ft batwing

   / Kubota 7040 with Landmark 15 ft batwing #1  

CBW

New member
Joined
Jul 16, 2014
Messages
1
Location
Waxahachie,Tx
Tractor
Kubota 7040
batwings will not lay down after being raised to vertical
 
   / Kubota 7040 with Landmark 15 ft batwing #2  
Check for selector above hyd port. Should be on single line in and out.
Yours is set for two line operation, I think....
 
   / Kubota 7040 with Landmark 15 ft batwing #3  
Check for selector above hyd port. Should be on single line in and out.
Yours is set for two line operation, I think....

There's no selector port on my '11 M7040. I just plug single or double acting cylinder into breakaways and raise/lower cylinders. Do you have breakaway couplers seated properly??
 
   / Kubota 7040 with Landmark 15 ft batwing #4  
Check your "books" I think that using a single acting cyl. requires using the proper (flow) direction outlet. On one (JD) tractor I had, I had to only partially move the valve lever with the single acting cylinders to lower.
 

Tractor & Equipment Auctions

2019 Chevrolet Silverado 4x4 Service Truck (A55852)
2019 Chevrolet...
2023 Jeep Gladiator Sport 4WD SUT (A55758)
2023 Jeep...
2016 TRAILSTAR 40FT DUMP TRAILER (A56129)
2016 TRAILSTAR...
2013 Honda CR-Z EX Hatchback (A55758)
2013 Honda CR-Z EX...
JOHN DEERE BA84 WORKSITE PRO ANGLE BROOM (A54757)
JOHN DEERE BA84...
2006 Chevrolet TrailBlazer SUV (A55758)
2006 Chevrolet...
 
Top