Kubota BX 2750 Snowblower

[Lockport]

Here's a video of my wife running ours.

Nice video. Although it seems like there was a layer of snow still on the ground AFTER your wife went over it. Was it not down as low as it should have or is that how it comes out?


I'm going to wait until October to buy the 2750.[/QUOTE]

As I have a gravel driveway I keep the skid shoes set to about an inch and a half to two inches with the concept in mind that when a layer of ice forms I will raise them but only say that and never actually have.

 

[NY_Yankees_Fan]

I'm going to wait until October to buy the 2750.

Jay,

If u have the $$ now, start calling around for prices, if u wait until October you and everyone else is looking and the old supply and demand story applies. I found a dealer who had a used unit in May and did not want to keep it around until the fall so I helped him with his space problem. Do not be afraid to call around, I found my unit in Mass.

The list price for the Kubota BX2751 Sub-frame w/Mid PTO kit is $995, and the BX2750 50" snowblower is $1610. eBay Store - Byrd Tractor Inc of Manassas: Kubota attachments: New Kubota RC72-27B 72 mid-mower for B2710 2910 7800

 

[lawn_king]

When i traded in my B7500 for my B3030, i sold my 2650 blower,2019 front blade & subframe for 2 grand, a tbn member came up from maryland in a flash to grab them! There are deals out there, just be patient and seek them out! New york yankees fan is correct on the timing, you need to get moving now on snowblowers, one serious snow storm & they will sell out for the season!

 

[jam2004]

When i traded in my B7500 for my B3030, i sold my 2650 blower,2019 front blade & subframe for 2 grand, a tbn member came up from maryland in a flash to grab them! There are deals out there, just be patient and seek them out! New york yankees fan is correct on the timing, you need to get moving now on snowblowers, one serious snow storm & they will sell out for the season!

Alright. My boss in on vacation this week. I'll shop for one while I work.

 

[jam2004]

BX2750B Manual 2 stage 50 inch snow blower 1458.00
BX2751 Qk Hitch subframe 431.00
BX2752 Mid Pto Drive Kit 445.00

Total 2334.00

Labor to instal (is this necessary?) 165.00

 

[NY_Yankees_Fan]

Labor to instal (is this necessary?) 165.00

Are they just installing the blower and subframe onto the tractor?? If so, I do not see why u should pay them, unless u plan to have them do it for u each fall and spring.

 

[jam2004]

I told them I would install it myself since I would have to install/remove in winter/spring. Doesn't sound too difficult.

 

[lawn_king]

I recall having to drill 2, 3/4" holes to install the subframe. It was a lot less labor if the tractor had loader stanctions.

 

[NY_Yankees_Fan]

I recall having to drill 2, 3/4" holes to install the subframe. It was a lot less labor if the tractor had loader stanctions.

Nope not on the BX, no holes needed to be drilled to mount the quick hitch. 4 pins hold it in place, in the same holes as where the MMM front supports are located. The only part u have to add is a protective shield under the oil pan on the engine. Two bolts and u are done, it has to come off in the spring since it hits the MMM.

Getting those 4 pins are a pain, BUT no tools are needed EXCEPT for a large hammer.

 

[SeymourBota]

The only part u have to add is a protective shield under the oil pan on the engine. Two bolts and u are done, it has to come off in the spring since it hits the MMM.

I don't take mine off, but I will admit that I think its proportions may have changed a little from the time of original installation!!!