kubota bx24 2009

   / kubota bx24 2009 #1  

dennynep

New member
Joined
Aug 29, 2009
Messages
2
Hi I was 3 degrees last night i let it warm up a bit then started the machine while letting it warm up all the sudden the was a lot of hydraulic oil The filter blow open. so my question is was there water in the system and the only place i can see to let moisture in is on the back hoe ram should i be spraying the rams so the seals don't dry out? And if so how do i remove all the moisture? thanks
 
   / kubota bx24 2009 #2  
When was the last time you change hyd. and filter?
Older B6100 had same problem.
 
   / kubota bx24 2009 #3  
What kind of fluid are you running? Kubota makes a Super UDT fluid that might flow a little better. When it’s really cold hydraulic fluid gets thick and that could have been the problem.
 
   / kubota bx24 2009
  • Thread Starter
#4  
Hey Thomas about 300 hours / 5 years Hi Dave i do believe it was some less expensive oil now i have the super udt in it. I removed the oil plug and moved the pistons on the backhoe and front bucket and steering wheel to try and remove all the fluid. I guess i'll have to see what happens.
 

Tractor & Equipment Auctions

New/Unused CFG Industrial MH12RX Mini Excavator (A54865)
New/Unused CFG...
2016 HINO 338 26FT BOX TRUCK (A56129)
2016 HINO 338 26FT...
2012 Crane Carrier Low Entry T/A Rear Loader Garbage Truck (A54814)
2012 Crane Carrier...
New Three Point Hitch Trailer Mover (A54865)
New Three Point...
HAMM HD+110i SMOOTH DRUM ROLLER (A52706)
HAMM HD+110i...
2016 Ford F-550 Crew Cab Mason Dump Truck (A51692)
2016 Ford F-550...
 
Top