L4060 HSTC rear remote, where to buy??

[zaceng]

Thanks everyone for your responses! I’ve seen plenty of open station solutions but not cab.. at least I know not to go with the oem valve

 

[MtnViewRanch]

Thanks everyone for your responses! I’ve seen plenty of open station solutions but not cab.. at least I know not to go with the oem valve

Use a diverter off of the loader valve. Good control valve, easy to plumb into the system, all the controls are on the loader joystick. There is your solution. :thumbsup:

 

[hokirenry]

That's the cylinders, not the remote kit. I have a hydraulic top link with the pilot valve hooked to my rear remote (L4060HSTC) and it never moves.

Brian generally doesn't mess with manually actuated valves for cabbed machines I don't believe. He also warned me & I found out that the rear remotes on the Grand Kubotas are crap. It's the least happy aspect on my L4060. I'm on my 3rd tilt valve & my tilt cylinder still leaks down in under an hour. My toplink is ok & only stretches an inch or 2 over a few hours, after they replaced it once. The crap cylinders from the dealer than never fit right & several leaked badly externally had the same issues (mostly relevant on the ones that didn't leak). Those cylinders got replaced by a pair from Brian at Fit Rite, which I have been happy with.

 

[Fallon]

That's the cylinders, not the remote kit. I have a hydraulic top link with the pilot valve hooked to my rear remote (L4060HSTC) and it never moves.

It's leaky valves, not cylinders. If you unplug the cylinders the leakdown stops. It also was an ossue with the 3 TnT cylinders the dealer tried before they gave up on finding ones that fit & or leak badly externally.

I'd more or less given up on getting the leakdown issue fixed. But I had a leaky QD spraying pretty good & was leaving town for a month. So I dropped it off at the dealer again to fix the leak & take another crack at the leakdown issue under warranty.

They put in a DPOV valve on the sidelink. As far as I can tell, it's fixed my sidelink. Toplink wasn't as bad & still has float. Sidelink no longer has float & the valve clunks loudly when activated. Plumbing & mounting is a bit ugly, but it does its job. DPOV is mounted above the 3 stack of QD holders & one of the 3 pairs is now empty. Sidelink no longer has a QD & is hard mounted to the DPOV. My lever operates backwards now. I either need to retrain my brain or swap hoses. Hoses are pretty tight, so not sure if can swap em. Lever is forward/back & motion is left/right so it's not like the lever was in the same plane. I'd be really annoyed if the lever was left/right & motion was right/left.