Lever wont stay on

[TraderMark]

Kim is right.
All of the older larger, true AG tractors had remote valves that detent both ways until the end of the cylinder stroke. Most of them had a way to defeat this feature if desired. I remember on the JD's it was a little plastic tab in the lever slot that you flipped up. That locked out the "auto detent" so it was non-functional if that's what you desired.

I'm not sure if they still offer that feature on the larger Ag tractors. Been a long time since I was a real farmer and had tractors that big.

I haven't ever seen that feature on a CUT. I think it's mostly because there are few people who pull wheeled implements all day long that require remote hydraulics to lift and lower.

Mark

 

[ole farmerbuck]

My dealer sent a tech up the other day to check the remotes out. He said they are replacing all 3 of them. They said Kubota rep said if they installed and tightened to book specs, then they are too tight! What about a service bulletin stating not to tighten to specs? Oh well.