Limiting Chain Ideas on a B2920??

[Howard92]

I guess my B2920 was designed to operate this way, but it is really annoying to have to keeping looking back there to see how far the front of my rotary cutter has sagged and them bump it back up to the correct height.

Seems like I have to bump it back up every few minutes. Anyone put limiting chains on limit how far the 3-point hitch can sag? I've looked at some chains on other tractors, but I have not figured out how to put them on my B2920. Or is there another solution?

Thanks for any help,
Howard

 

[McREBEL]

Check the link below:

http://www.tractorbynet.com/forums/kubota-owning-operating/68855-quarter-inching.html?highlight=quarter%20inching%20valve%20explanation

Another quarter inching thread:

http://www.tractorbynet.com/forums/kubota-owning-operating/212121-quarter-inching.html?highlight=quarter+inching

 

[jeff9366]

I installed Limit Chains on my Kubota B3300SU connecting to 48" KK Rotary Cutter. Simple solution, worked very well, perhaps better than Position Control on my current Kubota Grand L 3560 for Rotary Cutter operation only.

Zerco has been producing Limit/Check Chains for this purpose since the mid-1950's.

A good application of the Keep It Simple, Stupid (KISS) principle.

LINK WITH PHOTOS: http://www.tractorbynet.com/forums/...ta-b3300su-zerco-check-chains.html?highlight=

 

[GPintheMitten]

Jeff9366, nice job. I'll have to do that for my B2620.

I had chain limiters on an old 2N for a brush hogging many years ago.