Log Splitter

[KiotiJohn]

</font><font color="blue" class="small">( John, I have the 3pt TSC splitter on my L3430...as far as power..if you load it, it will split...have split cured 26" dia. sweet gum, no problem. )</font>
Thanks Garey. I've thought for a while that I might buy one of them, but wanted to hear from someone that they're worth the buy. Guess they are! Thanks again. John

 

[SteveInMD]

I rented a stand alone splitter today. I'd like to buy a splitter but I can't quit afford it this year. I was thinking I'd go with a 3 pt hitch type, but after today I see why it's important to have the tractor free. I split quit a bit of wood by hand (I like the old fashion method and the exercise) and mostly use the splitter for large or knotty pieces. I have pallet forks for my quick attach loader (IMO - everyone needs these) and could just about set the large pieces in place to be split using the forks. Having the tractor free so I could use the forks was a huge back saver!

 

[pd444]

I'm sure someone can set me straight here, but most of the 3pt splitters I've seen can stand independently of the tractor, thus two quick-connect hydraulic hoses are all that separate me from hopping on the tractor and scooting away.

So they way I’m seeing it:

3pt splitter--

Disadvantages:

I’ve got to disconnect two quick-connect hoses if I want to use my tractor in the middle of a splitting session.

I can’t use the splitter without the tractor. (Since most of the family and friends get their uncut wood off my property anyway, there’s no need to haul the splitter so I hardly consider this a disadvantage)

Advantage: About half the cost of an independently powered 23 ton splitter.

 

[SPaulsen]

I just had the opportunity to use my new Rankin 3pt splitter yesterday. Performance was exceptional. The splitter was never overworked. Cycle times were what I considered quick. The only part that was slow was having to reload wood. I cut a couple of cords last night, it took 2 1/2 - 3 hours. I have to admit that I perfer the horizontal position over the vertical unless I am splitting pieces that are 2-3 feet in diameter. I could go even faster if I had a 4 or 6 way wedge.

 

[rmlucasco]

I just bought a unit that attaches to the skid steer type quick attach plate on my FEL. I run it off my exsting FEL hydraulics. The 3pt. variety seemed more limited and would have required an additional hydraulic line. It can be run horizontaly or near vertically. Additionaly it can be stationed at any height - even in the bed of a truck. I can install or remove the splitter in 30 seconds so it isn't inconvenient. Cost me $625 new delivered.

 

[GoodGuy]

What brand is your splitter, where did you get it & do you have any pictures of your setup ?? I'm not familiar with a setup at the FEL using the hydraulics from the FEL.

 

[rmlucasco]

http://ramsplitter.com

I bought it from them through ebay. 15 bucks less than listed on their own site. They come in blue, green and orange to match your ride /forums/images/graemlins/cool.gif

Position the unit where you want it, disconnect the bucket hydro., connect splitter and apply bungee cord.

 

[rmlucasco]

Finally took some pics.

http://rmlucas.com/log.JPG

http://rmlucas.com/Split.JPG

 

[billbill1]

I've never seen a front mount splitter, SWEET!!!!!!

 

[Cliff_Johns]

That looks like a weapon. Really nifty. I can see some advantages to your set up, but I must say, it's just looks terrific.

Cliff