Traction Mahindra 4110 4wd won't engage

   / Mahindra 4110 4wd won't engage #1  

ranchita

New member
Joined
Sep 4, 2014
Messages
2
Location
Ranchita, ca
Tractor
Mahindra 4110
4wheel drive lever moves but does not engage front axle through transfer case. Has anyone had this issue and is there a shear pin that could be broken?
 
   / Mahindra 4110 4wd won't engage #2  
Good chance it's the shift fork, I've replaced mine a couple of times over the years. Worst case scenario is the gear or shaft is bad inside the trans - mine was once, it was the rear bearing on the 4wd shaft inside and required a rear split of the tractor for a bearing that cost me less than $4.00 at NAPA. The shift fork is a very simple repair. Drain the trans. fluid and remove the cover w/fork from side of trans to inspect. You can see the gear/shaft inside and check the fork for bending and/or wear. The forks aren't that expensive, I get mine from Galen at LaWall's who participates here.
 
   / Mahindra 4110 4wd won't engage
  • Thread Starter
#3  
Thanks for the tips. I pull that plate and have a look.
 

Tractor & Equipment Auctions

JOHN DEERE 100 CORN SNAPPER DRAWBAR ATTACH (A58375)
JOHN DEERE 100...
206320 (A57192)
206320 (A57192)
2016 MACK CXU613 MID-ROOF SLEEPER (A58214)
2016 MACK CXU613...
Giyi Pile Hammer (A57149)
Giyi Pile Hammer...
2013 Ford F-750 Pak-Mor 16 Yard Rear Loader Garbage Truck (A56858)
2013 Ford F-750...
2015 Ford Escape SUV (A56859)
2015 Ford Escape...
 
Top