Traction Mahindra 4110 4wd won't engage

   / Mahindra 4110 4wd won't engage #1  

ranchita

New member
Joined
Sep 4, 2014
Messages
2
Location
Ranchita, ca
Tractor
Mahindra 4110
4wheel drive lever moves but does not engage front axle through transfer case. Has anyone had this issue and is there a shear pin that could be broken?
 
   / Mahindra 4110 4wd won't engage #2  
Good chance it's the shift fork, I've replaced mine a couple of times over the years. Worst case scenario is the gear or shaft is bad inside the trans - mine was once, it was the rear bearing on the 4wd shaft inside and required a rear split of the tractor for a bearing that cost me less than $4.00 at NAPA. The shift fork is a very simple repair. Drain the trans. fluid and remove the cover w/fork from side of trans to inspect. You can see the gear/shaft inside and check the fork for bending and/or wear. The forks aren't that expensive, I get mine from Galen at LaWall's who participates here.
 
   / Mahindra 4110 4wd won't engage
  • Thread Starter
#3  
Thanks for the tips. I pull that plate and have a look.
 

Tractor & Equipment Auctions

2013 Peterbilt 337 Single Axle Day Cab Truck, VIN # 2XP2AN7X4DM195257 (A57453)
2013 Peterbilt 337...
43024 (A59228)
43024 (A59228)
2013 Ford Taurus SEL Sedan (A56859)
2013 Ford Taurus...
Enmark Z Spray (A53316)
Enmark Z Spray...
Leer Camper Shell (A57454)
Leer Camper Shell...
(INOP) 1966 FORD MUSTANG 289 (2) DOOR COUPE (A58375)
(INOP) 1966 FORD...
 
Top