Traction Mahindra 4110 4wd won't engage

   / Mahindra 4110 4wd won't engage #1  

ranchita

New member
Joined
Sep 4, 2014
Messages
2
Location
Ranchita, ca
Tractor
Mahindra 4110
4wheel drive lever moves but does not engage front axle through transfer case. Has anyone had this issue and is there a shear pin that could be broken?
 
   / Mahindra 4110 4wd won't engage #2  
Good chance it's the shift fork, I've replaced mine a couple of times over the years. Worst case scenario is the gear or shaft is bad inside the trans - mine was once, it was the rear bearing on the 4wd shaft inside and required a rear split of the tractor for a bearing that cost me less than $4.00 at NAPA. The shift fork is a very simple repair. Drain the trans. fluid and remove the cover w/fork from side of trans to inspect. You can see the gear/shaft inside and check the fork for bending and/or wear. The forks aren't that expensive, I get mine from Galen at LaWall's who participates here.
 
   / Mahindra 4110 4wd won't engage
  • Thread Starter
#3  
Thanks for the tips. I pull that plate and have a look.
 

Tractor & Equipment Auctions

LOT: (6) Office Chairs (A59076)
LOT: (6) Office...
2018 Honda TRX250TM ATV (A56859)
2018 Honda...
2019 Bomag BMP 8500 Trench Compactor (A57453)
2019 Bomag BMP...
Dvorak Model 3072A Hydraulic Ironworker S/A Towable Trailer (A59228)
Dvorak Model 3072A...
2010 INGERSOLL RAND  G25 GENERATOR (A58216)
2010 INGERSOLL...
LOT: (7) Wheel Loader Shanks (A59076)
LOT: (7) Wheel...
 
Top