Mowing Mahindra 4110 - 5' or 6' Rotary Cutter?

[Navasot]

The 1540 I tried ou before getting my 4110 felt a lot lighter to me, the extra weight is one reason I went with the 4110.

It is heavier than the 1540... I got it cheap lol

 

[coffeeman]

The 4110 would probably handle a 7 foot cutter. I've cut some awfully big stuff with my 4110.

I have ran an 8 ft Woods Brush Hog type cutter. My 4110 needs weight if operating on hills. The engine more than enough to use the cutter. But, for whatever reason, didn't put a slip clutch on unit.. Clearing brush a breeze when I wind up 8 ft cutter, lots of torque. However, stalling out on stump or something else stops tractor dead. I believe responsible for breaking tooth on big power take off gear. Since cutter doesn't have any belts to slip, a clutch is a must i believe. I would be happy with a 7 ft. 8 is a little too big , have to be careful.

 

[coffeeman]

Have an 8 foot Woods finish mower. Like it, handles great and cuts a lot.

Cheers...Coffeeman

 

[Keith_B]

I have ran an 8 ft Woods Brush Hog type cutter. My 4110 needs weight if operating on hills. The engine more than enough to use the cutter. But, for whatever reason, didn't put a slip clutch on unit.. Clearing brush a breeze when I wind up 8 ft cutter, lots of torque. However, stalling out on stump or something else stops tractor dead. I believe responsible for breaking tooth on big power take off gear. Since cutter doesn't have any belts to slip, a clutch is a must i believe. I would be happy with a 7 ft. 8 is a little too big , have to be careful.

My son-in-law runs the bush hog on 1000 rpm, then runs the tractor at lower rpms. He killed the engine when he hit a hidden pile of dirt over the weekend. I cringed when it happened, hopefully no damage. I run it on the 540 rpm setting with more throttle to the engine.

The 4110 is a beast for its size, lots of power in that Daedong engine.