Tiller Maschio Tiller Problems

[mjdtexan]

I believe the way mine works is the spring is on that bolt. That bolt has a spring on it. When turning the bolt it puts more or less spring tension against the chain.

Set it where you want it, then tighten the outside jamb nut to hold it there.

I can't quite picture what you have. Can you get a pic of the outside and inside of your tensioner- if you haven't filled the gear case with oil yet?

Here's why: If you don't have enough tension on the chain, the chain will slip under load and can damage the chain or sprockets. If too much tension, the chain cannot slip as designed when hitting a sudden, large shock load (rock, root, etc)

We want your hard work restoring this equipment to get it back the way it should be and in proper working condition.

- JC

I have filled it and used the equipment. Believe it or not the top bearing is now leaking. So, I will take it back apart and get you a shot of it. I have found the bearing for less than $10. I shoulda replaced every bearing. I'm going to this time.

 

[DiskDoctr]

I have filled it and used the equipment. Believe it or not the top bearing is now leaking. So, I will take it back apart...

Yep, sounds EXACTLY like one of my projects!

Considering the condition of the chain and such when you started, you might want to go out and put a few hours on it first. It will loosen everything up and any pieces of rust or grunge will come out with the oil.

You can either replace or finely filter the oil and return it to the case. (Shouldn't be any heat or anything, so the oil should be fine)

- JC