I am looking to buy a discbine to cut about 175 acres for hay. I want to get as big as possible and still get a good cut. The ground is fairly flat, but definitely has some roll and unevenness in places. Is 9' too big? I am worried about scalping and poor cutting. Many thanks in advance for your opinion.
Mower Width
- Thread starter belezar
- Start date
- Views: 969
pjbci
Platinum Member
- Joined
- Feb 10, 2012
- Messages
- 780
- Location
- Summit. Ms
- Tractor
- JD 4840, Deere 5075e, 450j, Cat D4k2, Kobelco 160, Volvo EC140el, deere 310, komatsu D31px22, IH 1486, MF 135, MHF TO35
How many pto hp is your tractor? Our 85 hp tractor is a good match for the 9 foot 10 inch or however many inch it is. It pulls it fine when the grass is tender. We hook it to a 145 hp tractor when the grass gets dry and tough in the summer.
I will get the tractor to fit the mower. With that amount of acreage, I want to be as efficient as possible (within reason). I was looking at a 85-90 hp tractor as well as a 120 hp. I don't want to pull 2 rigs, but do want to know if there are problems with width from a cutting standpoint.
pjbci
Platinum Member
- Joined
- Feb 10, 2012
- Messages
- 780
- Location
- Summit. Ms
- Tractor
- JD 4840, Deere 5075e, 450j, Cat D4k2, Kobelco 160, Volvo EC140el, deere 310, komatsu D31px22, IH 1486, MF 135, MHF TO35
I cut some very uneven ground with ours with no complaints. I certainly wouldnt want to go smaller. You will be pleased with cutter you mentioned. The 85-90 hp will do fine also. I just use a bigger tractor in the summer because I dont like to slow down a gear. Some people say I cut too fast, so if your not cutting @ 9mph you probaly wont have to slow down when the grass gets dry and tough to cut.
