MY Mods to a BX TPH

[8561]

I did this mod to my B2410 and I HIGHLY recommend it. It makes hooking implements far easier than those foolish turnbuckles.

 

[638]

The turnbuckles are a real pain in the ***. Kubota should be ashamed of them.

ron

 

[ndnparts]

I have not found a B2710 parts manual online, so it would be very helpful if you would scan and post the corresponding page with the part numbers for the diagram. Thanks. Stan

I'm at my other computer now and here is a picture of the parts, maybe you can print it out and show it to the partsman and you'll need 2 of item #170 and two of the #220, mount the #220 to the triangular shape plate between the lower TPH arms and cut a slot in the side of #170 to fit over the the tab on the rear end of the lower TPH arm. Just be sure to pay attention to the hole arrangement in the #170 before you make the slot, be sure you slot the correct end. Hope this is a help, I know you'll like the results.