Need help solving snow plow problem

[LD1]

Manifold is probably a crossover relief.

Any pictures of your setup.

It is highly suspect that it only dont work when pushing the lever to the right (normally bucket dump), because regen will do just what you describe. You either need to know if regen is first position on the lever or second, and whatever it is cannot be used.

 

[joe jed]

It does not move blade when I dump or push stick to right

 

[joe jed]

There is no second position not like when I push the stick up where it can go into float position

 

[LD1]

There should be two right positions on your joystick. Sometimes the detent can be really stiff and you just ain't pushing hard enough. Other times it can be hardly noticable and you are pushing past it.

Don't know if your regen is first or second position. But you can't use regen. It puts pressure to both hoses. Until you figure this out, not much help we can be

 

[bcp]

There is no second position not like when I push the stick up where it can go into float position

It may be there, but is very stiff since you haven't been using it.

Mine is like going into float, but to the right instead of forward. It is quite a bit harder push than going to float position.

Bruce

 

[LD1]

Anyone confirm weather regen is first or second on kiotis

 

[joe jed]

Anyone confirm weather regen is first or second on kiotis

I did some research and i have a la525 loader which has a regenerative bucket dump.

 

[LD1]

Kubotas typically have regen in first position. Wondering what it was on your previous kioti that worked for you.

I don't think there is anything wrong with the plow, as it does work in both directions by swapping hoses, so that proves the lines and cylinders are all good.

And I assume the bucket works as it should as well, so the valve is good.

I just don't think you are pushing far enough right to get past the regen mode on the valve. My Kubota has a stiff detent. Stiffer than the float detent as someone else also said.

Do you notice a detent at all? Does the lever move farther to the right than it does to the left? If the answer is no to either, you are still in regen

 

[J_J]

I believe there were some FEL valves maybe Kubota, that had full time regen on the FEL valve.

 

[LD1]

Manual should say for sure. That or the decal kn the valve.

If it is fill time regen, cant use the pair of sa cylinders