New wiring for Lights on an old Tractor

[BayouMan]

Finally, I am done with this wiring project!

I am very pleased with the outcome. The attached pictures show the finished product.

 

[BayouMan]

A few more pictures.

 

[BayouMan]

One thing this project has forced me to do, was to install a tow hook on the front of the tractor. The primary purpose of the hook is to give me a more convenient place to put my front binder chain. I hope to get that welded on this morning.

I ran across some neat fasteners yesterday and I used them to hook up the front lights. They come in either a 2 conductor hook-up up to 4 at the hardware store I use. I found out quickly, that if you didn't want a wire in that connector, too bad. You can't remove a wire after it is pushed in. I had never seen these before, but they sure do simplify a wiring project. Here is a picture of one of those connectors.


Thanks for the input.

Mike

 

[BayouMan]

OK guys, here is the final picture for this project. As I mentioned in a previous post, I needed to put a tow hook on the front of my tractor. I used to run my chain in behind the grill, when I hauled the tractor, but with the new conduit install, I had to come up with an alternative.

I had 2 of these hooks that came off of a jeep. Had a little difficulty welding it on, but I think it will work just fine.