Pat's Easy Change Pat's Easy Change System - longer top link?

[greg_g]

Click on the dealers link at the very bottom of this page

//greg//

 

[RollTideRam]

This would also work. JC
http://www.tractorbynet.com/forums/...nded-top-link-pats-ezchange-link-extender.jpg

 

[greg_g]

Thank you RollTideDam - that IS the exact photo I tried to describe in my earlier post.

//greg//

 

[bgWI]

RollTideRam,

Is the extender plate available for purchase somewhere, or a picture of what one can make to correct the situation of a short top link?

Moving the pick up point back 3 & 3/4 inches in my case should not reduce my lift capacity that much since my heaviest 3 pt equipment is about 1,500 pounds and I believe my stated capacity is about 2,400 - 2,600 pounds.

I had thought of cutting the ends of the lower arms but the slide extensions do not permit shortening. I asked my dealer about other "L" arms being a plain subsitute but he could not tell me if any of the "L" arms are the same as the G-L series.

thanks for the direction!

Bill

 

[RollTideRam]

I think this part was built by the man using it. JC
I went back and found the original thread.
http://www.tractorbynet.com/forums/...pats-ezchange.html?highlight=toplink+extender

 

[Copperhead]

My humble apology Copperhead, but I do not recognize "CCM." Please provide more information.

thank you,

Bill

Carter and Carter Machinery

Carter and Carter Machinery, Hay Equipment Headquarters