Piranha Pallet Forks/Tillers

   / Piranha Pallet Forks/Tillers #1  

JohnVa

New member
Joined
Mar 7, 2005
Messages
16
I have a Kubota L295DT with a FEL and Box Scraper.

I am interested in forks that could replace the bucket on my FEL. The Piranha Pallet forks seem to do that?

Am also interested in Tlllers. I think a 60" would be about right for me.

Do any of you use these or similar ones and have pictures you could share? All the pictures I have found showing tillers in operation have been super small.

John
 
   / Piranha Pallet Forks/Tillers #2  
As for the tiller, they work a tractor pretty hard. I dont think you would want to go over 60". Agri-supply has some less expensive ones or if you tell me where your at I may have some other contacts for you.I have not seen the piranha forks,you can do a search for forks on here and get alot of info on many types. Hope this helps. If your not on a budget your dealer can get you a nice set of forks also.
 
   / Piranha Pallet Forks/Tillers
  • Thread Starter
#3  
Creeper,

I am in Woodbridge Va, but my tractor is in Crossville Tn about 60 mi west of Knoxville on I-40. I do run up and down I-81 to get there /forums/images/graemlins/smile.gif

John
 
   / Piranha Pallet Forks/Tillers #4  
I have a set of Pirranha forks I use on my L4200… they are very well built and very handy. Don’t know who has the best tiller for the $ but a large tiller would make good counter ballast to use with the forks. .
Forks are on loader in attached . KennyV.
 

Attachments

  • 607967-Forks3.jpg
    607967-Forks3.jpg
    85.2 KB · Views: 193
   / Piranha Pallet Forks/Tillers #5  
I would reccomend trying these guys I will try to post a link here. They are right off 95 in petersburg. web page
 
   / Piranha Pallet Forks/Tillers #7  
Hello John,

Here's 3 pictures of my Bhuler FarmKing 60" tiller.
This tiller is well built and is probably going to last a long time for what I'm using it anyway. If I were to buy another one, I would go smaller because the garden I'm using the tiller for is a bit small /forums/images/graemlins/blush.gif But it's my dealers fault! I had agreed on a Agric 54" if I remember and brought me that one for no additionnal $! /forums/images/graemlins/laugh.gif

It does also make a good ballast for loader work!

Hypernix
 

Attachments

  • 608293-Tiller1s.jpg
    608293-Tiller1s.jpg
    73.3 KB · Views: 143
   / Piranha Pallet Forks/Tillers #9  
And picture #3

Enjoy!

Hypernix
 

Attachments

  • 608295-tiller3s.jpg
    608295-tiller3s.jpg
    78.4 KB · Views: 132
 

Tractor & Equipment Auctions

WEATHERFORD MP-10 TRIPLEX MUD PUMP POWERED BY A CATERPILLAR 3412 ENGINE (A50854)
WEATHERFORD MP-10...
1994 PETERBILT 379 SLEEPER (A50046)
1994 PETERBILT 379...
2005 CATERPILLAR 12H MOTOR GRADER (A51406)
2005 CATERPILLAR...
2016 CATERPILLAR 259D SKID STEER (A50458)
2016 CATERPILLAR...
2019 BOBCAT S770 SKID STEER (A51242)
2019 BOBCAT S770...
1998 CATERPILLAR D5M PIPE LAYER (A50854)
1998 CATERPILLAR...
 
Top