GolfAddict
Veteran Member
Nice progress!
Poor man's side by side
- Thread starter NS Gearhead
- Start date
- Views: 86257
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,905
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
:thumbsup: :applause:
OP
NS Gearhead
Veteran Member
Took today off to get a big chunk done. Here's four hours worth of work.
Passenger's side done
Started tracing fancy curved brackets for body mounts... then just did this
They actually had to be hammered in (pass side needed an 1/8" shim), so we'll see if they stay in place once the body starts moving on the trail
Metal work on the back is done! Turned around to get to the front
I HATE RUST!!!
Hit it with the flapper wheel to see what I was dealing with then cut out the worst spots
Then probably an hour later I had them all filled
Passenger's side done
Started tracing fancy curved brackets for body mounts... then just did this
They actually had to be hammered in (pass side needed an 1/8" shim), so we'll see if they stay in place once the body starts moving on the trail
Metal work on the back is done! Turned around to get to the front
I HATE RUST!!!
Hit it with the flapper wheel to see what I was dealing with then cut out the worst spots
Then probably an hour later I had them all filled
ericthewelder2
New member
Nice Project
Midniteoyl
Elite Member
- Joined
- May 20, 2013
- Messages
- 4,792
- Location
- N. W. Indiana
- Tractor
- Kioti CK3510SE HST, Ford 3400, Gizmow ZTR, Simplicity 7016H
Lotta work if your gonna get rid of it 
OP
NS Gearhead
Veteran Member
Thanks guys.
Meh, it's good practice for me, and a nice rig for whoever buys it... and with any luck I'll play with it a little to make sure it's all good before spring. The bridge is going in on the trail as soon as the frost is out of the ground... the goal will be to see if the Tracker can make it around by itself. Should be fun!
Lotta work if your gonna get rid of it
Meh, it's good practice for me, and a nice rig for whoever buys it... and with any luck I'll play with it a little to make sure it's all good before spring. The bridge is going in on the trail as soon as the frost is out of the ground... the goal will be to see if the Tracker can make it around by itself. Should be fun!
Green Power
Platinum Member
- Joined
- Dec 1, 2013
- Messages
- 964
- Location
- Nebraska
- Tractor
- LS R4047H, Kubota L33400 JD: 5075E 6150M 9230 and 8520
Nice work!
OP
NS Gearhead
Veteran Member
Thank you!
Forgot to mention; in my excitement for progress I forgot to prime and paint the back and top of that 2x2.
I'll do what I can reach and spray some rust check to seep into the rest.
KubotainNH
Veteran Member
I venture to guess that 2x2 will last longer then the rest of the vehicle but I get where you're coming from.