Hi
I’m rebuilding a couple of kubota 4-wheel steer garden tractors. One is a g1800 and the other a g1900.
Both have broken chassis and scars from a lifetime of abuse. However all the good bits are functional and a rebuild will have them as per design
New chassis are from 130mm cold rolled channel and are quite a bit more robust than original
As part of the rebuild, I would like to install a position setting hydraulic system for both the cutter deck and the (yet to be built) 3 point linkage.
This would mimic that in big tractors where a lever set to a position and holds that position to keep a constant depth or height as you work.
Is there a ready made sensor/control unit that can be purchased? To best of my knowledge there is nothing original. If there is please let me know. Otherwise aftermarket or adapted systems will
Have to be built.
Just hoping there is some sort of retro fittable “bolt on” solution rather than having to design form scratch
I’m rebuilding a couple of kubota 4-wheel steer garden tractors. One is a g1800 and the other a g1900.
Both have broken chassis and scars from a lifetime of abuse. However all the good bits are functional and a rebuild will have them as per design
New chassis are from 130mm cold rolled channel and are quite a bit more robust than original
As part of the rebuild, I would like to install a position setting hydraulic system for both the cutter deck and the (yet to be built) 3 point linkage.
This would mimic that in big tractors where a lever set to a position and holds that position to keep a constant depth or height as you work.
Is there a ready made sensor/control unit that can be purchased? To best of my knowledge there is nothing original. If there is please let me know. Otherwise aftermarket or adapted systems will
Have to be built.
Just hoping there is some sort of retro fittable “bolt on” solution rather than having to design form scratch
