FiredudeAT1
New member
- Joined
- Apr 4, 2024
- Messages
- 24
- Tractor
- Farmall Super A
On the Farmall Super A, is the heaviest wheel supposed to be on the driver's side? Mine is on side of the motor.
Question on weighted rear wheels
- Thread starter FiredudeAT1
- Start date
- Views: 1208
pmsmechanic
Elite Member
- Joined
- Dec 6, 2013
- Messages
- 4,367
- Location
- Southern Alberta, Canada
- Tractor
- 4410 and F-935 John Deere, MF 245
Depends on how heavy the operator is....
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
If I remember correctly, my 49 A had weights on both sides.
OP
FiredudeAT1
New member
- Joined
- Apr 4, 2024
- Messages
- 24
- Tractor
- Farmall Super A
It has weights on both but side opposite of driver has more. I would think driver side should have more since frame and engine is on the other side.
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,610
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
If you look at the wheels themselves, the right side should be a cast center wheel about 1-1/2" thick while the left is a pressed type disc balancing out the weight between sides I'm assuming for an average operators weight on level ground. And depends on what the PO mostly used it for. For instance, if they needed a little more weight on the left side for pulling a moldboard plow to keep from spinning, they may have moved the cast center to the left for that reason.
John0829
Veteran Member
The "A" I owned was weighted the same on both sides as was the "Super A" my parents had.
