MMM
Platinum Member
Not to start another debate, but I use ss bolts and nuts exclusively at work and never seize prevents the galling. We also use loctite242 without problems- seems to lube threads even when removing nut.
Removing exhaust header type, studs
- Thread starter Richard
- Start date
- Views: 3098
OP
Richard
Elite Member
- Joined
- Apr 6, 2000
- Messages
- 4,997
- Location
- Knoxville, TN
- Tractor
- International 1066 Full sized JCB Loader/Backhoe and a John Deere 430 to mow with
Thanks Junkman & Others.
I went out of town yesterday & my neighbor dropped turbo off at yet another neighbors...who seems to have been a machinest once in life and has some of the big toys in his shop.
He tried today to heat it up, it didn't budge. He told me he's going to try again and if it doesn't work, he'll cut them flush and then try to drill them out. Said he'd first drill a hole in them and use one of those reverse bits to try to remove it. Absent that working, he'd drill them out & tap new threads in there.
Brutus is outside laughing at me & my ineptness of fixing it... but it doesn't know I'm a persistent little creaton and WILL persevere.
/forums/images/graemlins/grin.gif
I went out of town yesterday & my neighbor dropped turbo off at yet another neighbors...who seems to have been a machinest once in life and has some of the big toys in his shop.
He tried today to heat it up, it didn't budge. He told me he's going to try again and if it doesn't work, he'll cut them flush and then try to drill them out. Said he'd first drill a hole in them and use one of those reverse bits to try to remove it. Absent that working, he'd drill them out & tap new threads in there.
Brutus is outside laughing at me & my ineptness of fixing it... but it doesn't know I'm a persistent little creaton and WILL persevere.
/forums/images/graemlins/grin.gif
Lazy
Platinum Member
- Joined
- Dec 20, 2003
- Messages
- 527
- Location
- Missouri
- Tractor
- ford 1920 w/fel and bh, case 470, allis chalmers B 1937, JD 450 track loader, Case vac, 3 cub cadets ford lgt 125, Kubota 2230/60 inch mower.1948 farmall cub 1953 farmall cub
Hi
I have removed studs that were flush with the block by placing a hex nut over the stud and with a stick welder weld the nut to the stud. Completely fill the nut with weld for strength. Hasn’t failed yet to remove the stud.
Charlie.
I have removed studs that were flush with the block by placing a hex nut over the stud and with a stick welder weld the nut to the stud. Completely fill the nut with weld for strength. Hasn’t failed yet to remove the stud.
Charlie.
