Thanks for all the ideas and tips. It's nice to know this fencing doesn't sounds like a show stopper on purchasing the property. And I guess it's better to have too much fencing then not enough, right?
Thanks again for all the posts, most helpful!
You should still be in black land out where you are, right? I'd say wait a while to move it. Like everyone has said, it may be just what you want after a while.
If you do decide to remove it I'd use a set of pallet forks on the tractor. Cut the rails near a couple posts then get the pallet forks near a post within the 'joint you cut out and lift the post out of the ground. Move down and lift the other one.
Your posts may be close enough that you can get both posts out with one lifting motion but I doubt it. Pull the 'joint' of fence up with the forks and have someone cut the posts off at the concrete.
Just leave the remainder of the pipe in the concrete, it's too time consuming for what it's worth to bust the concrete off the stub. Use these stubs with the concrete around them to fill in ditches, holes, etc around your place. They could also be used in holding down wire on a water gap if you have the need.
After you do some of this you should have a few good trailer loads of scrap pipe to sell. Either take it to a scrap dealer and sell it by weight or peddle it to individuals. Or, just hag onto it. It'll come in handy someday if you have a place to store it.
For the price of a gas powered cut off saw you can buy a pretty good torch set up and lease some bottles for a year. You'll need them anyway sooner or later- and it'll be easierto cut the pipe with a torch. Be careful not to start a fire you can't put out.
Mount your torch rig on a trailer and leave room for a welder and compressor later. That way you can pull it along the fence as you cut, pull, cut, pull, etc.
Now, what will do do with the holes left from the fence posts you just pulled out?
