I was wondering if anyone has ever had a rough running / backfiring issue when they had a loose pole on the starter ? It’s a 12 volt system and everything else seems to be ok but the stud on the starter is loose and will not tighten up properly. Any help would be appreciated thanks!
Roadworthy
Elite Member
If the starter spins the engine it's doing its job. For rough running look into your timing or something else in the ignition - points, condenser, distributor cap, wires, etc.
EdGooding
Gold Member
- Joined
- Sep 12, 2016
- Messages
- 321
- Location
- Montpelier, VA
- Tractor
- 2006 Massey-Ferguson MF-1533, 1973 Ford 3000, 1952 Ford 8N
Is it backfiring through the carb or the exhaust?
LD1
Epic Contributor
Need pics and more detail.
The loose pole could indeed be the problem, because I believe the pole on the starter is used to basically distribute power to the rest of the tractor. IE: the starter pole is used as as the common distribution point instead of the battery terminal. So wiring issues there could indeed cause issues.
Fix what you KNOW isnt right....like the starter. Then begin troubleshooting
The loose pole could indeed be the problem, because I believe the pole on the starter is used to basically distribute power to the rest of the tractor. IE: the starter pole is used as as the common distribution point instead of the battery terminal. So wiring issues there could indeed cause issues.
Fix what you KNOW isnt right....like the starter. Then begin troubleshooting
EdGooding
Gold Member
- Joined
- Sep 12, 2016
- Messages
- 321
- Location
- Montpelier, VA
- Tractor
- 2006 Massey-Ferguson MF-1533, 1973 Ford 3000, 1952 Ford 8N
