Pirate
Gold Member
Drive is about 500' with half being real steep. I don't know the angle but I do know that if I stop my minivan while driving up, I need to back all the way down to get going again. It angles off to one side all the way down. Halfway down there is a 90 degree turn.
Problem is, over time tire grooves have formed on one side, really bad at the turn, and now the rain collects in that groove, runs down instead of off to the side, creating even more problems.
This drive is only 7 years old. I lost count of the number of loads of crusher run that have been dumped on it. This was the first year I didn't need another 20 tons. I think it was generic crusher run (receipts say #25) and not number 21a crusher run. The stones are all real small.
Would it really matter to use 21a vs. 25? If so, should I scrape down what I have a lay down 21a?
Can 't afford to pave it.
Thanks.
Problem is, over time tire grooves have formed on one side, really bad at the turn, and now the rain collects in that groove, runs down instead of off to the side, creating even more problems.
This drive is only 7 years old. I lost count of the number of loads of crusher run that have been dumped on it. This was the first year I didn't need another 20 tons. I think it was generic crusher run (receipts say #25) and not number 21a crusher run. The stones are all real small.
Would it really matter to use 21a vs. 25? If so, should I scrape down what I have a lay down 21a?
Can 't afford to pave it.
Thanks.
Last edited: