TC18 60" MMM
- Thread starter TC18guy
- Start date
- Views: 1991
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Re: TC18 60\" MMM
</font><font color="blue" class="small">( Worst part about that is, it is under the tractor. You would have to get wax to run UP!! )</font>
Don't worry.. it will /forums/images/graemlins/shocked.gif.. it will 'wick', due to capilary action..
Soundguy
</font><font color="blue" class="small">( Worst part about that is, it is under the tractor. You would have to get wax to run UP!! )</font>
Don't worry.. it will /forums/images/graemlins/shocked.gif.. it will 'wick', due to capilary action..
Soundguy
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Re: TC18 60\" MMM
</font><font color="blue" class="small">( the bolt is broken flush with the transmission housing )</font>
Ideally, you would start with a stub.. however.. flush is still doable.. You put a nutright over the hole.. use one that only gives you access to the broken piece.. not the sourounding area... probably end up being a smaller nut than the bolt head was.. but should still work...and then be carefull about only welding the shank to the nut.. stick welder with a small 1/8 rod probably easiest way to do this... once it isn't red anymore, try it.
Soundguy
</font><font color="blue" class="small">( the bolt is broken flush with the transmission housing )</font>
Ideally, you would start with a stub.. however.. flush is still doable.. You put a nutright over the hole.. use one that only gives you access to the broken piece.. not the sourounding area... probably end up being a smaller nut than the bolt head was.. but should still work...and then be carefull about only welding the shank to the nut.. stick welder with a small 1/8 rod probably easiest way to do this... once it isn't red anymore, try it.
Soundguy
kennyd
Advertiser
Re: TC18 60\" MMM
Soundguy explained it well(better than me).
If your FIL is a decent welder, this should be no problem.
Soundguy explained it well(better than me).
If your FIL is a decent welder, this should be no problem.
