Torn ball joint boot

   / Torn ball joint boot #1  

rlee6

Silver Member
Joined
Jul 1, 2004
Messages
199
Location
Central Florida
Tractor
Allmand 8435 HST (TYM T330 HST)
The rubber boot of a ball joint is damaged. It is on the front axle and doesn't seem to be too difficult to replace (part may be expensive). If I scrape out the dirt and seal up the area with silicone glue (Permaflex), will I be able to get more hours from it?
 
   / Torn ball joint boot #2  
worked for me, i used automotive "goop" instead of silicone, it seems to grip better. once i put the stuff on i wrapped the joint horizontally with duct tape tight and left it for a couple of days then took the tape off. let it set nice.

mike
 
   / Torn ball joint boot #3  
Don't be cheap. Pop the joint apart and get a new boot. i've seent he rubber parts on the shelf at napa.. cheap insurance..

Soundguy
 
   / Torn ball joint boot
  • Thread Starter
#4  
I wish I had taken a picture of the ball joint. It has a flat top, just like a typical sealed unit. But it also has a grease nipple on the side. My neighbor, who is my coach on almost everything (tractor, plowing, culvert driveway, etc), says it is a sealed joint and I can leave it as is. Does it make sense to anyone?

Soundguy,
I didn't know the rubber boot was a replaceable item. I thought the whole control arm had to be replaced. That's why I wanted to get as much life from it before replacing it. Thanks for the advice.
 
   / Torn ball joint boot #5  
Well.. if must come apart to be attached right? How similar to a tie rod end is it?

If it has a grease fitting.. that tells me it is not a 'never needs service' part..

Doest it have a urethane donut around it?

Soundguy
 
   / Torn ball joint boot
  • Thread Starter
#6  
I've seen rubber boots held by steel bands. On this one I didn't see a band or anything that appears to be removable. I will take a closer look at the boot. In the meantime I will visit a NAPA store for boot and filter cross reference. Thanks.

PS: I don't know what you mean be a urethane doughnut. I didn't notice anything that fits "urethane doughnut" on the ball joint. I will inspect carefully next time.
 
   / Torn ball joint boot #7  
Chris:

Last time I had a urethane donut, it was a Crispy Kreme. /forums/images/graemlins/grin.gif

What exactly is a urethane donut? I don't have a clue unless you mean the spacer washer.
 

Tractor & Equipment Auctions

2014 Chevrolet Tahoe 4x4 SUV (A52377)
2014 Chevrolet...
2018 TAKEUCHI TL12V-2 SKID STEER (A51242)
2018 TAKEUCHI...
Kubota SVL65-2 Open Station Rubber Block Tread Skid Steer (A55218)
Kubota SVL65-2...
2003 Big Tex 10PI 16ft. T/A Pipe Top Utility Trailer (A52377)
2003 Big Tex 10PI...
2015 KENWORTH T270 SERVICE TRUCK (A51406)
2015 KENWORTH T270...
2015 Ford Escape SUV (A50324)
2015 Ford Escape...
 
Top