Tractor side SS quick attach build

[mwb]

I removed my cylinder brackets from my bucket and reused them on my SSQA , for me it was just as easy to do that then build a new set. Also using a plate is a good idea, I had a set of factory built pallet forks a friend loaned me, and used them , made a real nice jig for fitting and tack welding together and everything I've hooked to so far has fit really nice.

:thumbsup: +1 on reusing the existing cylinder brackets. I could not reuse them on my Montana but did so on a 'bota L3400. The Kubota worked out perfect. That Kubota bucket had a lot of really nice welds! I made a post about that installation here also.

 

[2TALLTARY]

Delrin was a good idea. It is the best machining plastic around. It's kind of the workhorse of the plastics industry. I use it to make gears and screws i buy from Delrin Sheet, Delrin Rod, Acetal Sheet and Acetal Rod | Industrial Plastic Supply, Inc.. Great material.

 

[perks1018]

Have you patented this build, and if so, have you licensed it out for manufacture? It is definitely marketable.