Using an L6060 With Stationary Implements

[bdhsfz6]

I zip tied the switch lever down on my old L3200.

Still trying to figure it out like you are for my L4060hstc with air ride. I have a PTO generator I'm rebuilding & will want to run without me in the seat at some point. The cab negates my need for standing & the lack of clutch means I can just turn the key to start it without that clutch sensor.

Ok, here is the fix for using stationary implements on a ROPS model L6060 with the OEM (Grammar) air ride seat. It should work for other 60 series and cab model tractors as well. The process took about an hour.

First remove the wiring harness cover below the right fender console.

Locate the 2 pin connector with the black and blue wires leading to the seat.

Open the connector and install a jumper on the tractor side.
I made one using 2 - #3 female spade connectors.

With a little adjustment, they fit the tractor connector pins snugly.

I chose to do it this way so as not to modify the tractor wiring harness.
Pull the jumper, snap the connector back in place and the tractor is OEM.
If you wish, you can cut open the wiring harness behind the seat.
Short the blue and black wires to bypass the seat switch.
Make sure you use the correct black wire since there are two of them.