Hey all - I don't have much hydraulic experience and am a bit confused about what exactly is on my tractor and my options. It's a CX2510 with backhoe. There are two ports on the rear. To operate the backhoe I move the fender lever to "A". There is a B position, as well as center. It is not spring return to center.
Kioti is calling this a "remote". Is it actually a power beyond? I guess since they don't get looped when backhoe is off it's not PB (also no relief or tank connection). So the way it operates is the opposite port (depending on lever position) will return to tank?
Is this compatible with a hyd top link with a double-piloted check on the cylinder? I just have to make sure to return the lever to center after adjusting... or I'll go against relief in the tractor?
I asked Kioti when I ordered the tractor about adding a traditional spring return to center remote/lever but they don't offer an additional one.
Thanks!
Kioti is calling this a "remote". Is it actually a power beyond? I guess since they don't get looped when backhoe is off it's not PB (also no relief or tank connection). So the way it operates is the opposite port (depending on lever position) will return to tank?
Is this compatible with a hyd top link with a double-piloted check on the cylinder? I just have to make sure to return the lever to center after adjusting... or I'll go against relief in the tractor?
I asked Kioti when I ordered the tractor about adding a traditional spring return to center remote/lever but they don't offer an additional one.
Thanks!
Last edited: