Using bucket as work platform.

   / Using bucket as work platform. #41  
3RRL said:
OK, so the way this thread is going the next question is...
Has anybody used the 5 gallon plastic bucket while inside the fel bucket?:confused: That sounds interesting...
Personally, I would never use a 5 gallon bucket as a step stool...I'm too uncoordinated. I have a 2 step stool for that stuff.

Unfortunately, I have physically seen, at least one person standing on a step stool, in a loader bucket.

i have also seen a ladder on a pallet, that was on a forklift.

The ladder one didn't scare me as much as seeing the stool inthe laoder bucket..darwinism and gamblers at work I guess...

Soundguy
 
   / Using bucket as work platform. #43  
With no bucket truck or climbing hooks, I guess you have to improvise.:eek:
 

Attachments

  • !cid_000701c6e8ca$5b5a4c00$dfd57cce@user7df2d1b60d.jpg
    !cid_000701c6e8ca$5b5a4c00$dfd57cce@user7df2d1b60d.jpg
    31.4 KB · Views: 552
   / Using bucket as work platform. #44  
Ok, I gotta tell ya, that looks dangerous as all get out! I wouldn't do it.
 
   / Using bucket as work platform. #46  
GIJOE said:
With no bucket truck or climbing hooks, I guess you have to improvise.:eek:

A lot of pictures like this get criticized without the critics knowing the whole story. I've heard this was a bystander rescue of an electrocution victim. If so, it's good to know someone had both the ingenuity & fortitude to get the job done. MikeD74T
 
   / Using bucket as work platform. #47  
Lifting people in tractor buckets is foolish. When a person falls they are moving very fast. Yes, I know this from personal experience :eek: (I was swept off a ladder, NOT in a bucket). Greg
 
   / Using bucket as work platform. #48  
I have stood in a fully raised bucket,on a JD 5205 with a "chain saw on a stick" and cleared branches. I have climbed a 3 section ladder that was chained straight upright to a forklift to change 8' lightbulbs 30' up. I have pulled a dead man out of a tree ,that he cut down onto himself, 40' up into a firetruck bucket. I have climbed a radio tower then jumped 4 ' to the 2nd story roof of a sawmill,with a firehose(empty) in my hand. I will climb just about anything no worries,but I dont care much for going under ground.
 
   / Using bucket as work platform. #49  


Using a milk crate to stand on... Theres more reasons why they have that theft warning.
I stood on one, and both feet broke through. causing the plastic to make , like a one way trap. If I tried to pull my legs out it would dig into the skin:eek:
Had to crawl to get the saw zall and cut my way out.
I laugh at it now...:)
 
   / Using bucket as work platform. #50  
Thought I would add to this post... I am guilty. I use my FEL for a work platform sometimes. The reason, is that in some instances, it is much more practical, and safer than a ladder. I have found that its real handy to install a tree stand with. But like anything, you have to be careful.
-Brad
 

Tractor & Equipment Auctions

2018 John Deere XUV560E 4x4 Gator Utility Cart (A50322)
2018 John Deere...
F-800 POWER PUMP 800 HP TRIPLEX MUD PUMP POWERED BY 3412 CAT ENGINE (A50854)
F-800 POWER PUMP...
2018 FREIGHTLINER CASCADIA TANDEM AXLE SLEEPER (A51222)
2018 FREIGHTLINER...
5K BLOWOUT PREVENTER (A50854)
5K BLOWOUT...
2013 MACK GU713 (A50854)
2013 MACK GU713...
Yale 50LX Cushion Tire Forklift (A49461)
Yale 50LX Cushion...
 
Top