Snowblower Which snow blower

[TMBRWLF]

Hi all and Merry Christmas. I've been looking at getting a front snow blower for my 1739e. In my 60s now so lm not turning around to plow our 1/4 mile drive. I have enough pain without adding neck to the list. I saw a blower that looked good ( Pronovost p680 front blower ). The MF shows 11.3 gpm flow. Still not sure without a phone call to see their ratings. I believe one site listed 11-14 gpm for this model. Does anyone have info on this or other models that will work on my quick attach? Not stuck on the Pronovost, just looking for something that will work on the front. The MF 1739e is a manual not hst and don't believe there's a mid mount pto. If needed, l could look into adding that if it's even an option. Since the E model is not a premium, not too sure of mid pto stuff.

 

[Peter 315]

I don't think that one will work hyd front blower usually need high flow....

 

[RjCorazza]

I believe you are also quoting the total flow, rather than 7.2 gpm that is available.

 

[TMBRWLF]

Will have to get out the book. I thought it was 14+ total gpm but i'll look. I also thought that model was a low flow which is what l was guessing id need. So many questions. lol

 

[TMBRWLF]

Ok so l was way off. Book says 6.7gpm main system & 4.2gpm on the steering.

 

[TMBRWLF]

Guess l'll be looking for a blade as im not putting a 3 point on the rear.

 

[CobyRupert]

11.3 gpm is shown as total flow. 7.2 gpm is shown for SCV, and 4.1 gpm for steering.

TractorData.com Massey Ferguson 1739E tractor information

 

[Peter 315]

What size so we can spend all your money...... 84'' power angle, quick hitch.....

 

[TMBRWLF]

Well Coby 10.9 is close to 11.3 lol
Peter my wife keeps ALL the money hehe. I don't really have any problem blading over snow blowing, just thought it would be nice. Since it's a open deck not a cab. Maybe l'd be better blading not eating the snow the wind decides to push my way???

 

[TMBRWLF]

Oops 10.8 not 10.9. ocd...