POC
Gold Member
4 pneumatic jacks at the corners.
Why did I wait so long
- Thread starter Hookblock
- Start date
- Views: 6027
sandman2234
Super Member
- Joined
- Dec 4, 2005
- Messages
- 6,673
- Location
- Jacksonville, Florida
- Tractor
- JD2555 and a few Allis Chalmers and now one Kubota
If air is a problem, and you don't move it around a lot after it gets put in place, four nuts welded to the bottom corners, with a bolt screwed into it. Just back the bolt out till it takes the pressure off the caster. Cheaper, more of a pain, but it doesn't leak down when the air bleeds off....
David from jax
David from jax
joes_427_vette
Veteran Member
- Joined
- Aug 10, 2004
- Messages
- 1,273
- Location
- Midwest
- Tractor
- IH Cub Lo Boy, 955 John Deere , TC 55 DA New Holland, Bolens HT 20 and 1456
Found the missing link today. 1/2" x 39 x 56 plus a piece 42 x 20. #420 @ .45 # Winter project. Would like to trim the 42 to 39 and mount it so it could be fliped up on the end for longer pieces. I have the short pieces for the base. I like the straight edge idea for the front. How high did you make it Hookblock ?
joes_427_vette
Veteran Member
- Joined
- Aug 10, 2004
- Messages
- 1,273
- Location
- Midwest
- Tractor
- IH Cub Lo Boy, 955 John Deere , TC 55 DA New Holland, Bolens HT 20 and 1456
I was planning the 3' mark. I'm 6'4" so I didn't want to be leaning over too far.
Joe there are some good ideas here WeldingWeb - Welding forum for pros and enthusiasts - Powered by vBulletin
