Why did I wait so long

[POC]

4 pneumatic jacks at the corners.

 

[sandman2234]

If air is a problem, and you don't move it around a lot after it gets put in place, four nuts welded to the bottom corners, with a bolt screwed into it. Just back the bolt out till it takes the pressure off the caster. Cheaper, more of a pain, but it doesn't leak down when the air bleeds off....
David from jax

 

[joes_427_vette]

Found the missing link today. 1/2" x 39 x 56 plus a piece 42 x 20. #420 @ .45 # Winter project. Would like to trim the 42 to 39 and mount it so it could be fliped up on the end for longer pieces. I have the short pieces for the base. I like the straight edge idea for the front. How high did you make it Hookblock ?

 

[Hookblock]

Joe, the table is 35.5''

 

[joes_427_vette]

I was planning the 3' mark. I'm 6'4" so I didn't want to be leaning over too far.

 

[Hookblock]

Joe there are some good ideas here WeldingWeb - Welding forum for pros and enthusiasts - Powered by vBulletin