YanMar 2210 Factory Crack spec's???

[Chris Schurmann]

YanMar 2210 Factory Crack spec's??? Does anyone know what the factory Crack specs are for a 81 2 Cylinder 2210 Tractor. Also if its handy I would also like the spec's on the cam and rods.. Thank You in advance.:cool2:

 

[winston1]

According to Hoye's parts the 2000 and 2210 use the same crank and rods so here is what the I&T manual shows for the 2000.

 

[Chris Schurmann]

Thank You! Going to go and see about get the crack turned, its a long shot but I have a contact at Bullet racing cams and they can turn it as long as its not cut to deep for 185.00 verses 450.00 for a new one.

Thanks Again!

 

[normde2001]

According to available bearings they can turn the crack .030".

 

[bmaverick]

According to available bearings they can turn the crack .030".

That's about right since my John Deere mechanic said the same thing for my Yanmar 3T80 in a JD-850. Are we talking crack or crank here

 

[normde2001]

That's about right since my John Deere mechanic said the same thing for my Yanmar 3T80 in a JD-850. Are we talking crack or crank here

I kept seeing "crack", so assumed it must be some type of code.

 

[winston1]

I kept seeing "crack", so assumed it must be some type of code.

KGB may be in on it.

 

[Pete Judd]

Wife says I need to readjust my "spenders" because I am showing more crack. Other wise the felons at the end of the road, could educate the rest of us on "crack".

 

[careyo63]

What I thought also. I know with the new Fad of Wearing your your Draws down around your Hips. But 30" of Crack ? That did sound a little much or either on it.