RadarTech
Elite Member
Ok.. I have to admit, when I greased the loaded last weekend it just would not go into the lower right hand pin on the loader...
so after checking the grease gun, removing the zerk, testing that, swapping the fitting with the one above it, and pushing grease thru it I am confounded...
My next step is to remove the pin altogather and see what the issue is...
BUT I wonder has anyone had this problem before?
when the grease is applied, it just comes out right there at the zerk...
UGGG....
does this make sense?
ideas?
thanks,
J
so after checking the grease gun, removing the zerk, testing that, swapping the fitting with the one above it, and pushing grease thru it I am confounded...
My next step is to remove the pin altogather and see what the issue is...
BUT I wonder has anyone had this problem before?
when the grease is applied, it just comes out right there at the zerk...
UGGG....
does this make sense?
ideas?
thanks,
J