Out of the blue my 2006 TC30 decided not to turn over. This was after I already ran it on Sunday, attached finish mower, took off grapple and prepared it to mow. Came back after lunch and tractor will not turn over. Long story short...5 amp fuse blown, and other blow as soon as you put them in...
Help! I have owned this tractor less than 6 months but sometime after I bought it and checked all fluids I have lost over 2 gallons of HST hydraulic fluid!!
Tractor sounded very "whiny" yesterday afternoon, like it was either very cold or under strain and it was not cold out so after taking...
I have done quite a bit of reading and I now know why I was directed to this forum from attachments regarding hooking up the third function on my new Econo-Grapple.
I am trying to think through the choice I have between doing my CHEAPIE 3rd function or doing CHEAPIE rear remotes.
This is my...
I purchased a WIX 46438 to replace the outer Air filter on my 2006 TC30 and after pulling off the old outer I cannot get the filter case back together using the WIX filter. It has a small round bulge on the top of the filter which is higher than the old filter if I sit them side by side on the...
I thought I would pass along a few notes about the removal of the freeze plug needed to do the block heater install. With a screwdriver sitting on the inside edge of the plug I first tapped the screwdriver with a hammer. Then I got serious and then I punched a hole through the freeze...
I got the block heater in my TC30 :D but I have an awful lot of wire and have no idea where I should bring the plug out at. I did the first tie to the main wire going into the starter. I have no idea where to go from there. If I let it dangle at all I will need to protect the plug with some sort...
TC30 Block Heater and Transmission Heater advice
I have my block heater but the instructions do not cover my specific tractor, a TC30 (2006). All the other models are grouped on the instructions and it tells you which plug to take out and what position to mount the heater.
Still want to make...
Took my first trip to the NH dealership since becoming a New Holland owner (2006 TC30). I need a block heater since I will be using this CUT:D this winter. Almost bought it online but decided to checkout the dealership. Called ahead to make sure they had a block heater for my TC30, they put my...
I have now had the tractor 10 days and I have a long weekend coming up to get some work done with it.:thumbsup: Previous owner says he "JUST LEFT IT IN 4WD". I have not done much with it so far but what I have done is in 4WD.
What do you guys do? Leave it in 4WD or use it only when...
I picked up my used 2006 TC30 HST w/Rhino 2408 loader :D(less than 350 hrs) on Tuesday. Prior to this I have owned a 1962 Ford 2000 with a HUGE loader and a 1959 Ford 641 Workmaster which I a about to sell. I mostly mow and do road and pasture maintenance. I acquired horses last year and I...
I have had small tractors for 11 years now but yesterday I purchased my first diesel. :D Previous experience was older Fords 1958 to 1962 with my last being a 641 WorkMaster. I needed four wheel drive and a front loader to help me deal with winter snow and haying horses. I now own (owe on) a...