I have a Ford 1715 with similar issues described elsewhere.... I need a little help: Where can I find the access to adjust the PTO clutch? Is it on the bell housing? Is it under the front end...

I have a 1995 Ford 1715 which has become stuck in gear. Hi-Low range but it wont come out of 2nd gear. I took plate off and can see the gears which appear to be OK. No obvious signs of damage...

So per my other thread from a couple of weeks ago, our Ford 1715 had fuel filling up the crankcase while it was sitting, not running. Figured out that it was o-rings in the injection pump. I know...

So it's not in my yard yet, but I'll be picking it up this coming Tuesday. But for now, here is the posting for it on...

THE TPH IS PULSING UP AND DOWN ALL THE TIME, I TRIED TO ADJ LINKAGE FOR HPL VALVE AND SAME PROBLEM. IS THIS A LEAKING TPH HYD CYL OR A HPL VALVE PROBLEM OR SOMETHING ELSE ? THANKS, :confused:ROGER.

Is there a source for aftermarket rear wheels for the 1715? OEM is about $1,000. It uses the 6 lug, wheel that fits a 11.2 x 24 tire ... although the rim itself might be a 10 x 24. I have a...

Bought a 1715 w/BH loader from a equipment broker in Louesiana about 5 months ago. Tractor is showing 1100 hours but was not running and very little history on it. After getting it home I have...

Hey all, It is time for me to replace the clutch on my 1715 tractor. messicks.com has all the parts in stock. But I can not find the gauge for setting it. The manual refers to #FNH 1300 as the...

I am looking at a Ford 1715 4WD, 9x3 transmission, Ford 7108 quick attach loader w/60" bucket, single lever control, P/S, weighted turf tires, with 400 hours, in excellent condition. Not sure on...

I purchased this little tractor a couple of years ago mostly for the front loader. It is in really good shape with very low hours and appears to have been well taken care of. I use it now mostly...

I am needing to replace the clutch in my Ford 1715 tractor. I have the service manual supplement pictured, but am needing Manual #40132030. It is the 13, 15, and 1720 Repair Manual. Anyone have a...

Hi -- I am looking at a house that has a Ford 1715, 4wd, FEL, 1200 hours parked out back. It has not been run in a few years, tires are good. It has been under cover. I'm thinking I can get it...

Looking at purchasing some implements for a newly acquired Ford 1715. This is my 1st tractor that I've personally owned so learning as I go. Need some recommendations on brands/sizes for the...

:newhere: I would like any and all information on the ford 1715 4wd. I purchased one this past spring and have used it all year. It's a 1994 with 765 hours on it. It seams to be operating...

Hey all, New here and new to tractors. Picked up an old Ford 1715 to help clear some land. Love it but the hydraulics are cavitating at high RPM. Here is what I’ve done so far. -replaced fluid...

Having a problem with a 1996 ford (new holland) 1715 pto Spent some time looking at other posts about similar issues and don't see the same type of problem. * Pto will not stay engaged while...

The drifting of the main lift and the bucket curl has increased over the last few months to an unsatisfactory level. I have been reading a lot of posts on this site discussing related problems and...

I tore the tractor down about a year ago and rebuilt it. I just got it all back together and pushed the clutch in and tried to get it into gear. All it would do is grind. I looked through the...

Dad started our Ford 1715 up a couple of days ago, and did something it's never done before. It started blowing oil out the breather tub that connects to the top of the valve cover on top of the...

Hi, I realize there is no absolutely right answer but I am buying my first tractor. Using it for thining about 40 acres of woods trees are 10-20 yes old, mostly 6 inch in diameter or smaller...

Forgive me for the basic questions... this is the first tractor I've owned and it's been a LONG time since I operated my granddad's tractor (that was a Ford 1720). My granddad has recently passed...

Im putting a clutch in a ford 1715. Im looking to see if anybody knows what the torque specs are on the bolts for the pressure plate to the flywheel? Any help would be appreciated! AB

To some of you guys in the know. looking to buy a compact for light hogging and yard work. 1998 JD 770 or a 1997 Ford 1715 both have loaders and just over 1000 hrs and both very well maintained...

Hey guys, in your opinion, will my ford/ Nh 1715 handle a 6ft shibara tiller? This tiller seems to have thin curved tines, so i thought it might cut into my clay rich soil. The owner of this...

Got the old 97 ford/NH 1715 out to again this afternoon to mow again. After about 15 minutes it ran out of power and just managed to get it back to the barn. This has been a good old tractor and I...

I have a ford1715 that is leaking at the transmission where the driveshaft meets it, hydraulic fluid is almost pouring out. Not sure what the seal is called or how to replace it. Have tractor...

I have a 94 Ford 1715 4wd that has been getting stuck in gear. It started grinding more than usual when shifting into second and reverse, then one day while pushing a brush pile it got jammed in...

The wife says we have to cull the herd, so I'm going to sell my Ford 1715. 1996, 4WD, loader, about 400 hours. Good overall condition with a new clutch installed. Any opinions on a reasonable...

This may be a dumb question... but it's Day 1 of tractor ownership for me. Picked up a low hours Ford 1715 yesterday. Unloaded it off the trailer this am and made a couple laps around the yard...

My uncle overhauled a 1715. I am looking for some advice as to how much weight I should keep my disc harrow around? I plan to use this tractor for food plots and bush hog work in the woods. Any...

I just bought a Ford 1715 with a 5' brush Hog and FEL. So excited except for small problem: I am having trouble with the PTO disengaging while mowing. The PTO just stops turning even though I am...

My original muffler broke away from the bottom "L" section a couple years ago and I replaced it with a smaller one I found at Tractor supply that fit the old "L". This noticeably decreased my fuel...

I am looking to replace the oil in my 4WD gearboxes, but the manual doesn’t list an oil type or capacity. The drain plug is at the bottom of course but the fill hole is clear in top of the case...

i just installed a new stoll 350 h loader hooked hoses up by color loader wil only move when raising 3pt hitch does any one have any ideal whats wrong

I am trying to help an old man with an ignition switch problem with his tractor. Does anyone have a wiring diagram of this switch? It is a diesel with a place on the switch for the glow plug. I...

Hello, I have a 1995 Ford 1715 4x4 compact tractor with approx. 800hrs. Tractor has worked great until yesterday after bush hogging for approx 1/hrs. It appears to be stuck in second gear. I...

I want to put rear hydraulic connectors on the rear of my ford tractor. I think the best way to do it on a ford is to split off the inlet side of the hydraulic manifold block and make a loop in...

Hoping to find some of you guys familiar with hydraulics that can give me some advice on where to begin looking for a solution>> I have developed a hydraulic problem with my Ford 1715. First the...

I'm in Florida looking at a 1993 Ford 1715 4x4, power steering with 1000 hours on it. Its in good shape and has a new quick disconnect loader. What would be the book value on this tractor or is...

Helping a friend with a Ford 1715 (Shibaura ?) 3 cylinder diesel. While chasing another problem, we dropped the water separator bowl. Of course that put air into the fuel system. We were able...

Just bought Ford 1715,,4wd,,the tires a very worn,,it has 9.50-24 rears and 6-14 fronts,,i have access to a set of 11.2x24 rears,,,just wondering if this will mess up the 4 wh dr,,looked at...

What is the recommended routine maintenance on a Ford 1715 and intervals? Like oil change, grease, hydraulic filter, fuel filter. Ever 50 hours, 3 months??

Looking at two used compact tractors. 1. Ford NH 1750 w/loader 100hrs for $11,900.00 2. Ford NH 1910 w/loader 800hrs for $9,800.00 Was wondering if these prices were fair that the dealer is...

The adjustable side link on my tractor is worn out. The threads on bottom and cemter sections are barely holding and it often slips a little when I hit a bump. I've looked at replacing the whole...

I'm looking for some feed back on this ford 1715. It's a '97' with just over 1000 hrs on it. The seller is the second owner and has had it for the last 15 yrs. It comes with the loader and the...

So I learned from my other thread about fuel mixing with the oil while the tractor isn't running that the seals on my injection pump need to be replaced. I know I need to pull the pump and...

I received a Ford 1715 and all the wires to the starter are disconnected and hanging. Can someone provide a close up pic of the starter with all of the cables connected? IE Battery, alt, key...

Good morning! I just picked up Ford 1715 tractor yesterday (2wd and doesn't have a FEL). It's my first tractor, but the same one my grandad had growing up. I'm in need of a trailer for it and...

My Father In-Law has TWO Ford 1715 tractors and both have Tachs with inop hour meters. RPM part of tach works fine on both. Any suggestions on where to get two, and/or get them repaired... and...

I've been casually looking for a 4wd used tractor, w/ loader and bushhog in the 20-30hp range. A Ford 1715 w/ these specs just popped up on a local Craigs List. It has about 1300 hours and they...

I'm in Florida looking at a 1993 Ford 1715 4x4, power steering with 1000 hours on it. Its in good shape and has a new quick disconnect loader. What would be the book value on this tractor or is...

Im putting a clutch in a ford 1715. Im looking to see if anybody knows what the torque specs are on the bolts for the pressure plate to the flywheel? Any help would be appreciated! AB

Just bought a Ford 1715, the tractor runs good but has a good deal of blowby, I knew this when I bought, didn't give a lot for it, I was wondering if I could just drop the pan and push the pistons...

do you have to remove the final drives and ring gear and pinion to remove the sprag clutch for the pto on a 1715 4wd ford

I just bought a 1715 with 600 hrs . The tractor has a non live PTO that does not work. When the PTO is engaged it spins but very slowly at any RPMs if I put pressure on the PTO like my foot it...

Just got this ford 1715,,am having a problem with the pto engaging, the pto will engage but is not staying engaged,, the lever feels sloppy,,I feel like it is going to be a problem with the shift...

Anyone know where I find the brackets that attach to the tractor for a 757c? or does anyone have pictures or dimensions of the brackets. Wid=fers beating me up for having the attachment for 3...

Looking at a used Ford 1715. Owner says it has just over 1K hours. Says clutch was never replaced. I know the clutches on the 1715 tended to have issues and are cost prohibitive to fix (I don't...

While removing the front, right, tire on my Ford 1715 4-wheel drive, I broke the heads off of 5 very solidly rusted bolts. Then while trying to extract one, I broke off the extractor tip. I...

1715 Ford New Holland 7350 won't drive reverse or forward. Goes into all gears HML still won't move does make a hissing sound. Filters cleaned not the problem. 4x4 was stuck still won't move...

I'd love to add a remote, but have very little info on how to do so. I saw a thread on Yesterdays Tractors, where a guy was able to fab up a manifold type block that allowed him to tap into the...

which can i get to new ones after market tractor has 7-14 tires on it

have the spanner nut off but cant get it apart is there something else holding it

Looking at a 1715, fel, 1000hrs seems to be in good shape comes with a few implements and has several new parts, orc, rebuilt front cylinders, new hoses. Does 8500$ seem right? Also what are some...

buynh-ML-551824-ML- Moved to New Holland/Ford buying pricing.

Could someone give me an idea of what to ask for my 1715 4wd diesel Ford tractor? Has about 600 hrs on it and is equiped with an after market front end loader. It is in very good condition. :cool2:

Dear All, Well I am finally tired of not being able to use the three high gear due to the clutch slipping so I am headed for a tractor split:( I have split the back 1/2 before to replace the...