Hi fellas, can anyone help me identify this hose on my father-in-laws 4025? It runs from under the seat down through the floorboard and connects underneath the machine. The hose is leaking...

I am having a problem with the nimco cv 112 controller when I move the joystick left and right to control the bucket I get absolutely no respons at all and the joystick acts like there is no load...

While trying to connect a bucket to the AML 333 Quick Attach System I discovered one side was tilted more than the other side. Using the hydraulic controls I could tilt forward or backward nut...

I have a 4025 that has less than 300 hours on it. That said, I've only owned it for about 2 runtime hours of that (haven't really started using it regular yet). When I test drove the tractor...

For the past few weeks, I have been plagued with the screen in the tank stopping up. It has been suggested pressure washing the tank then washing it with clean fuel to get the water out. I sure...

For the past few weeks, I have been plagued with the screen in the tank stopping up. It has been suggested pressure washing the tank then washing it with clean fuel to get the water out. I sure...

I just bought a 2013 Mahindra 4025 4x4. I have a line that started leaking, the line comes from under the seat and runs to the bottom of the tractor. It has three bajo fittings under the seat...

I just bought a 2013 Mahindra 4025 4x4 and a line started leaking that comes from under the seat. The problem is that it is leaking gear oil and Mahindra says it is not supposed to be gear oil in...

Need a change from narrow 3 rib front tires to a fat flotation tire of sorts. 2 wheel drive with loader, it will get stuck in a min. Please I don稚 want to break the bank and don稚 want to take the...

I have a Mahindra 4025 and the fuel line from the filter to the pump is leaking at the bottom crimp, can I just cut it there remove the crimp and slide the line over the tube and use a hose clamp...

Anybody put an aftermarket backhoe attachment on the Model 4025 Mahindra? Say a WoodMax or Ansung, etc..

I have a 2013 Mahindra Model 4025 2WD tractor. Almost without failure....if I run the tractor for say 45 minutes to an hour......it starts losing power....(starving for fuel....seems the...

I have a 2013 Mahindra 4025 2WD tractor. Been looking at purchasing a 3-point backhoe attachment. I spoke to the local dealer today (where I bought this tractor new)......he says they have a new...

The back story I've gotten is Mahindra didn't make fuel tanks with great lining. If the diesel gets any fungus, that eats the tank lining, which exposes the steel to rust. My 2014 4025 has under...

Over the weekend, moving tree limbs with my new Titon forks, I noticed the left QA plate wasn't engaged in the forks. I stopped working and attempted to force it back into the locked position, but...

While brush hogging today I thought I had fell in a hole but it turned out the front left wheel had cracked in half (not vertically but completely around the rim). I can see what appears to be a...

Temp and fuel gauges on 2012 mahindra 4025 stop working. I changed the fuel timer (relay) because it had a raddle like something was broken inside, but that didn't fix the problem.

Mahindra 4025 (4WD) Problem #1 - I have a Mahindra 4025 (4WD) with the loader. When going backwards and using the float feature on the front bucket control valve, I have to manually hold the...

Our 4025 4WD tractor has what is apparently an older design clutch and brake pedal setup. The tops of the pedals are relatively smooth and several times my foot has slipped off the clutch pedal at...

Manual no help. Google search for images,diagrams no help. Various part site search engine,part guide no help. I'm tightening the bigger plug/nut back and about to need a cheater bar. That goes up...

Drained the diesel and cleaned filter yesterday. A friend gave me 3 buckets of diesel as a friend,for letting him use it and for hunting on land. Was pouring one in and hadn't gotten to the last...

First day of working with my "new" 2012 Mahindra 4025 4WD. Has about 1120 hours on it. I reversed to drag and spread some gravel up a slight hill using the loader. When I depressed the clutch...

I went to use the tractor today and noticed some oil all over the rim. Looks like the seal is bad. I've never replaced a front axle seal and I do worry about tearing it apart and biting off more...

Forum I am new to plowing ....and tractors Hooked up the plow to my 3pt , but I cannot get the plow to break into the ground. I have Position Control on lowest and Draft Control deepest setting...

My question is a simple one, but I can't find any information online or in my manual. The manual says I need to clean this strainer after 50 hours, and now is the time. It does not say I need to...

I couldn't get my tractor to start after using it for a while today and started checking the basic fuses and was getting no power to the starter when turning the key. I checked the safety switches...

hello to all and thanks in advance for the help, i replaced the alternator on my tractor and now the rpm gauge doesn't work. it worked fine before. any ideas would be greatly appreciated...

I have a very new (4hrs) Mahindra 4025. Bush hogged for 2 hrs and all of the seat nuts fell off. I fixxed the seat. Tractor started right up. Drove it about 100 ft and started to lower the bush...

Hello all, I have a brand new 4025 4x4 with loader. I had to work on the seat as all of the nuts vibrated off after 2 hrs of bush hogging. Replaced the nuts. Tractor started right up, moved it...

hi and thanks for having me as a new member. tuesday night here in middle tn it got well below 0 degrees, my tractor cranked on wed and i was backing up to a roll of hay it died and has not...

The manual for the mahindra 4025 suggest cleaning the transmission oil screen at 100 hours along with changing the tractor fluid. Other than removing the right side running board and brake...

I am looking for a loader for my 4025 2WD that I just got. Any suggestions on good aftermarket loaders(or other equipment)?

Hi everyone...new here . Just found this sight while doing some research. Anyway in may I bought a new Mahindra 4025. I got with the loader only. Now I'm thinking about adding a a backhoe. My...

I hear a clicking sound when my tractor gets under load. I just bought this tractor and don't know a lot about it. Please help. It only makes it when wheel stops turning under a load. Is this a...

Hi All New to the board. I recently bought a Mahindra 4025 which I'm already in love with. Added a few mod's, sun canopy (basketball backdrop), aux. lights, grapple (versatech). So the problem I'm...

I have a mahindra 4025 and I want to know when checking the transmission do I put the dip stick to the start of the threads or screw it in?

Hey everyone. First post...Actually 6th i see as i edit. Don't remember what the heck i posted about previously. Member since 2010. My needs are varied so sorry for long post. I want a compact...

Looking to buy a new Mahindra 4025 4wd with the R1 tires. Received a price qoute of $14,750. Sounded like a good price to me but wanted to the opinion of the experts here and see if anyone else...

My fuel jelled on my Mahindra 4025 and was told to change fuel filter and add power service 911 to the fuel. Is it possible to thaw out the filter without replacing it?

Hello tractor experts, I am looking to add a tractor to the shed and would like to hear of some first hand experience with a couple of these models. So an outline of what I will be expecting out...

I haven't checked anything yet but I figured I'd post here just for ideas what to check when I get home this evening to make the most of what little daylight Ill have. This morning I got up and...

I just purchased a 2012 Mahindra 4025 2WD at the KS state fair. Sadly the tractor is out of town and I have to wait for the fair to end for it to be delivered. Hoping for early next week. You guys...

I traded my 3616 cab for a new 4025 4wd! I got it with a loader and R1 tires. The guys at Artec flipped the tires to make it as wide as possible since there isn't a flat spot on my land...

I will start off by saying this my first post. I really have enjoyed reading all of the info on here. Good stuff!!! I have 40 acres that I own and have another 50 I look after for deer hunting...

I am having a problem with my 2wd 4025 - it will not start - the range interlock appears not to be functioning as the key does nothing when turned - battery full charged, fuel good, oil level good...

OK guys two simple questions that should be in the owners manual. First do you screw in the engine and trany dip sticks to check oil level? Second, I'm about to do the 50 hour filter and screen...

Just found pic. please dirgard last post thanks:cool2:

Just got a auxiliry valve kit from Mahindra with no instrction how to install. Kit #E007206864B91 need visual help (pictures):D thanks

Hey tractor experts, I've just purchased a 13 acre property with a 3 acre pond. Maybe another acre is covered by trees which won't need to be maintained. The rest is open pasture. I'm not going...

I cut a tree down yesterday and it fell the wrong direction... so now its across the driveway and I was cutting it up and dragging it into the pasture to burn it. The tree was over 5ft across at...

I got my first Mahindra today 4025 w/loader (2wd). tried her out on some brush piles and works great. I do have one question. the exhaust blows down but not very far so it all ends up right...

Hello everyone, I just bought a Kioti 4WD DK40SE with their free loader (KL-401) program two days ago. Total price out the door, including sales tax was under 20K (5.5 % financing). Originally...

I have looked long and hard trying to use a limited budget to the best effect. I really wanted used, but most equipment of interest was far away. Locally (within 300 miles) did not show a lot of...

I have a Mahindra 4025 with a FEL. My question is how do I hook up a TSC 3-Point Hitch Log Splitter. I have never done anything with hydraulics before.

Thinking of trading my 2000 ford w/ select-o-speed tranny in on a 4025. I will pay cash and they tell me The differnce will be $8,000 ....Good deal?

Just wanting to know if anyone has used Pat's System on a 4025?

So I'm going to hook up a post hole digger that direct connects without the top link bar. The post hole digger is cat-1, but the top link pin that comes standard is cat-2. The cat-1 pins go...