Loader Grapple bucket?

[RollTideRam]

You need the 3rd scv installed and the hardline kit that runs to the end of the loader arms.

 

[John Henry]

this is what I have to operate the grapple

 

[morthog1957]

How hard will Deere "hit me" for this?

 

[John Henry]

Frontier grapple bucket around $2300,diverter valve - $350,less if you get at surplus center,control handle for loader - $70,hydraulic lines from john deere - around $250-300 for kit

 

[kennyd]

you have to have 2 auxiliary hydraulic valves on the FEL

Wrong answer You only need 1 valve for the grapple. The OP stated hes has a rear remote already, that will operate the grapple perfectly.

There is a kit from JD to extend the rear remote coupler up to the mid section where the FEL couplers are, and then up the loader boom. It's a complete bolt on kit and very easy to install.

 

[kennyd]

this is what I have to operate the grapple

Frontier grapple bucket around $2300,diverter valve - $350,less if you get at surplus center,control handle for loader - $70,hydraulic lines from john deere - around $250-300 for kit

Welcome to TBN

That is WAY overkill for what the OP needs, however it is a very nice setup.

 

[kennyd]

You need the 3rd scv installed and the hardline kit that runs to the end of the loader arms.

Exactly. And he already has the 3rd SCV.

 

[John Henry]

yes,I know you could use the rear remotes.I also have that kit but for me,it's easier to use the control knob on loader handle.

 

[kennyd]

yes,I know you could use the rear remotes.I also have that kit but for me,it's easier to use the control knob on loader handle.

Where did you get that handle for $70? I paid $175.00 for mine!

 

[John Henry]

The knob was from a takeuchi mini excavator which I modified to fit the tractor